Recent content by Shawn Morin

I removed the bottom of the valve to clean / remove any water (there was no water by the way) and unfortunately have no idea how this goes back together. First pic is of the pieces that came out when I removed the two allen screws. There are 4 small ball bearing, one larger one and a spring. All...

Hi Guys, I primarily use my tractor for moving snow. I noticed my last time out that my FEL "up/down" controls are not working properly. For example, when I pull the lever all the way down to raise the FEL, it moves super, super slow. If I just barely push down on the lever, the FEL actually...

Yes this is the Convex mirror from AutoZone. It was $9.99 where I live. I think you could improve upon how to mount it compared to how I did, but essentially the "clamp" has a 3/8 thread that you can add a bolt or in my case I used an eye bolt and then a few washers to take up the extra...

I finally found the right size clamp. The "bar" is 1 1/4" diameter so you would think the 1 1/4" clamp would work. Not so... turned out the 1" clamps inside diameter is actually 1 1/4". Weird, but now I know. No vibration with this setup either...

Added this to my Kubota L3600 today! As you can see, I need to find a smaller (1 1/4") split ring clamp. 1.5" with the "spacers" works for now.

Hi Guys, My name is Shawn Morin as the username suggests. :) I have a Kubota L3600 that I primarily use for snow removal. I've been a "lurker" on this forum for a few years and figured it was time to hop into the fray... I want to thank those of you who are so helpful to "newbies" like me...