Recent content by stoyan79

That's not bad.

Brand new TYM 2515 is about $20k. It is identical to 3515, except fuel is turned down. Loader lift is 2,200 lbs. Brand new with warranty.

Ausra in Michigan.

FB marketplace is full of cheap forklifts. They are amazing to have and usually last long time and not bad to work on. Make sure you get 3 stage mast if you want to lift high, plus those are easier to sell later if you decide it's not for you. Get common brand/model because for $3k it will be...

Most cheap forklifts are for flat paved dry surface only. Most have old school Japanese engines that last forever as they never see high revs and run very clean on propane.

Got this 4820CH in 2023. So far very happy. I paid $29,500 check, but now I think it's a bit more. Same as 5520, just no turbo. If you want a cab, that is it. Old Branson design, pretty heavy build (over 5,000 lbs). No electronics, no sensors, old school Bosch mechanical pump. If you take off...

If your tractor has a loader then you need ballast. Period!

Isn't 5055e made in India by Mahindra?

The T25 and T394 have been in TYM line up for a while and have Yanmar engines, the T754 most likely retains the Deutz engine, as I don't think Yanmar makes 74hp engine? I think engines are made by Yanmar and shipped to TYM assembly plant, don't think TYM makes the Yanmar engines.

I would think not much. Yanmar must have lots of faith in the TYM models though, they are covered by the same 10 year power train warranty.

Kubota economy L and MX are my favorite tractors, but I needed a cab and didn't want to spend $50k+.

TYM is currently most budget friendly. 55hp (2,700 loader lift) without a cab can be had sub $30k, with cab just a bit over $30K.

Yes, it is, but the whole tractor is made in Korea by TYM. Yanmar America and TYM Sign Supply Agreement for Tractors｜2023｜News｜YANMAR USA

TYM now makes 3 models in Yanmar line-up.

Kubota mx6000 or l6060, both are amazing. They have zero down, zero percent right now.