Recent content by Tigershark

I believe it was in the first pic I posted. I sold the tractor so I can't taken any more pics but with the hydro it was up under shifter in front of the back left tire. It was not fun to punch out because it was tight and mine was broken. Once it came out it was easy to put the new one in. I...

Sale pending

Width is 82.5 inches at the rear wheels Weigh probably around 8500 with the backhoe it will fit on a 20ft trailer that's what I used to haul it

Yes

With pallet forks I have unloaded 2500 pounds with the bucket I would think close to 2k I have unloaded several pallets of seed but I use my pallet forks I'm not sure I could get 2k of dirt in a 6ft bucket but the capacity is around 2500#s I have had a full bucket of rocks #3s and dense...

Nice tractor upgraded to a 95hp for farming Well maintained 900 hrs hydrostat, aftermarket led lights, AC, heat, blue tooth with Kioti backhoe 18" and 12" buckets 2 remotes 3rd function WR long kit for grapple etc loaded ag tires Titan tires great shape stance is set wide 82.5"

Thanks for the reply I hadn't thought about trying to get it it from underneath. The spring is right by the cab level right now I have a piece of wire in place and when I want it turn it on I just pull the wire out lol

My pto spring broke and I’m pretty sure the only way to access it is to remove the entire ride side console that covers everything. Is there an easier way ? Is it as big of a PITA as it looks? Assuming all the plastic caps are going to need to be replaced afterwards. Right now I have a big...

Thank you for the suggestion I will do that

I really appreciate all the advice Thank you It's got hydraulic lines running from one of the rear remotes to the front for a third function I now have to figure out how to disconnect the hoses they aren't like quick disconnects I am used to with skid steers and other tractors so there must...

took the cover Off the loader handle and oiled the joystick where it attaches above the cable because it seemed a little tight. After moving it around Back and forth it was smooth again and sure enough it lifts at idle now. Really appreciate everyones help

Checked the cables they are in good shape no wobbles pretty tight hydraulic filters were changed around 50hrs before I bought it according to the service records

I really appreciate the advice I will look tomorrow and report back again thank your for the help

I don't believe so Would it be obvious if someting was wrong ?

2100 and it had been recently serviced when I bought it It doesn't even get to pick up the bucket unless I rev it up but if it is up it will curl, and go down without reving up if it is already raised Thanks for the reply