TMGT's latest activity

Thank you

Thanks, and I know. If you're going to call someone out on misspelling one word, you should probably proofread your own post first!

Thanks for the heads up, I corrected it. My phone kept insisting on changing laminated to lamented for some reason. Thought I corrected...

Was able to get all the mounting parts cut out, all 1/2" except for the spacers for the bushings which is 3/4". Not shown is the peice...

It's a Kubota M4711, which is a rebranded Bradco 611. The holes are to allow me to weld the 2 outer layers to the middle layer besides...

Had this project on the list since I got the backhoe a few years ago, finally got around to actually making it. I had been playing with...

I just use velcro for strap management, you can buy a 60ft roll of 3/4" for about $13. It's reusable, works for storage and excess strap...

The adjustment is behind the left rear wheel, i just had to do it to my 2680 when I added the deck. There's lots of videos and info on...

Have to disagree about the Vulcan cart, I have one I use for my XMT 304 with a 24a feeder. My only complaint is the tank holder is too...

I only use the G6 for leaf cleanup. They were well for breaking up dry leaves for the collector, but they do like to blow out the front...

I wouldn't recommend closing off the discharge with the G6. They aren't really made for enclosed mulching and, depending on grass type...

Really shouldn't run steel wire in your aluminum liner, the steel wire can be pretty dirty and leave contamination in the liner, which...

I've run into sae thread fittings on some Kubota loaders since a lot are made in the US, I've had some tractor mounted fittings be...

I assume you mean a L3540? Are the fittings on the tractor or an attachment like the loader or backhoe?

I always hated using zip ties for the ends, switched over to metal crimp cramps a few years ago. Look much more professional and less...