TMGT's latest activity

Test fitted it on the tractor today, happy with its range of motion, so now I just have to finish the welding and add a grease fitting...

So scrap an entire vehicle because of 1 defective part? Makes total sense. Not enough information to know if damage has occurred or...

Gerotor oil pumps are usually either fine or have catastrophic failure, such as a broken outer rotor. It could be the pump, but most...

Most likely it wasn't true zero but extremely low. If it was the service writer is telling you this, I'd take it with a grain of salt as...

Lemon law pretty much covers problems that can't be fixed or are excessive. Warranty covers defects such as a bad part.

I've been very happy with the cut quality of my Bx2680 with the 60" deck, I also had a bx1870 with 54in deck for a short period of time...

That's common due to the leverage on the cylinder, unless you have a lock valve. Are you running it vertical? If you're just using it...

Do you mean the tilt function? Unless you have a lock valve on the cylinder, you will get some leakdown. How are you using your mower...

I run a 78" on a similar size/weight tractor, a Kubota L3240 with loaded R4's and a loader. I had a very steep road of milling in front...

Was able to get a little shop time in today, welded up the shank and mount. Had a little trouble getting the welder dialed in for the...

When I was hauling cars, there was a Wendy's near my local auction that I was able to take my truck and trailer through. F550 with a...

Machining is done, now I just have to weld it up. My work schedule isn't allowing me as much shop time as I'd like, hopefully I can...

It does, I still have some finishing touches, but I built one for it earlier this year.

More like just over 7gal, but he said it was a gal low, so closer 6gal. Without knowing compatability of the fluids its a gamble, it...

Is it a gear or HST? If gear, I probably wouldn't worry about it. If it's an HST, I would change the fluid out if it was my personal...