Recent content by tommu56

Tape will not prevent moisture getting in, solder creates a "rigid point" in the wire and is prone to brake on edge of solder regular heat shrink will not stop moisture Ive been there many times Ma Bell has been using scotch locks for years on the phone lines with the jelly in them to exclude...

2 years ago our cabin in the mountains of Central Pennsylvania burnt down here is the new one going up. 36 x 36 8' high with 8' attic trusses attic will be 20' x 36' long The opening is not a garage door it is picture window omitted to get stone and cement in. This is only their 2nd day on...

Amazon.com: NEW 12V 11T CW STARTER FITS RHINO 3320 3324 4134 HERCULES 2282 2284 TRACTOR QD1247A: Automotive

I use a kerosene siphon

Have here take lug with here they should have a screw type lug to replace it with if they don't go to a electrical supply store and ask them for one I would avoid aluminum set screw connectors as they will corrode fast. some thing like this ILSCO...

Here is an up date there is a way to add apps (I've done 2 so so far) on kindle fire hd. You have to have android phone or have source for the app (xxxx.APK file)you want. and a computer and cables to move the files from phone to kindle Down load es file explore app to the phone and to kindle...

water bar is name of them for roads it doesn't have to be that aggressive just an inch or so would work in the correct direction. tom

JDGirl I took some liberties with one of your pictures A quick test would be to make sure tractor is off and stopped and tie the 2 out board blades in position with a 1/4" expendable rope or 3 or 4 lengths of baler twine. Make sure no one else is around and start tractor put pto in gear...

From 2307 Will also need to look into adding some dirt banks or something at the driveway entrance to divert the water away from coming down the left side of the driveway and down behind the shed. put a small mound in drive called a water bar to direct water were you need it to go. or some...

I have a leak on my front axle I don't see what keeps the bearing and gear on. I disassembled it to change the upper bevel spindle seal and it stayed together. Did any one else have to change one??? tom

These bits are for sheet metal no thicker than the steps for sure use a hole saw. tom

I'd second the 4" grinder to sharpen them and then balance them with a cone thing. tom

Look at LED tape lights for under counter http://www.amazon.com/Lighting-EVER-Flexible-Waterproof-Ultimate/dp/B0085UPTJO/ref=sr_1_5?ie=UTF8&qid=1364022820&sr=8-5&keywords=led+strip+warm

mobile app for kindle i cant find one and search for"app" strikes out.

I have some scaffolding in the corner of my garage to stack stuff on. I'm keeping my eyes out for some used pallet rack and beams. I do have 2 bikecycle lift's from HF holding bikes up in the rafters. They might work for light john boat but change the rope the thin rope they supply gets...