TractorTech's latest activity
-
TI think if that tractor was under my supervision I'd remove rear trans cover for a visual inspection of rear differential.
-
TTractorTech reacted to PopsGallardo's post in the thread John Deere 410C PLEASE HELP! with
Good Post.
Thank you guys for your replies and information. I appreciate your time and I guess I’ll be dropping the transfer case again! UGH! -
TI just started my weed eater that's been sitting with 2 year old 87 octane E10 gas on the 6th pull. Runs great. I started my Toro...
-
TTractorTech replied to the thread John Deere 410C PLEASE HELP!.Welcome to TBN! It sounds like you broke your differential side and/or pinion gear(s) on the differential. #9, 10
-
-
TTractorTech replied to the thread Ford 5000 power steering. To repair, or update?.Pretty sure I heated the tapered pin to get it loose.
-
TTractorTech replied to the thread TC29 Buying with Transmission Issue, Pass or Risk It?.Welcome to TBN! Hard to tell whether you would need to split or not, but my guess is, being a prison unit, the shifter was forced and...
-
TTractorTech reacted to johnesc's post in the thread Deere 4720 wheel seals/ wheel hub internals with Good Post.
The front hub seal, LVA14181, cost $42 from deere , it’s Dana part number S20HH106, $9 from drivetrainamerica.com
-
TTractorTech reacted to AlbionWood's post in the thread Ford NH 1920 front wheel drive hydraulic seal repair with Good Post.
Got this done! Getting the old seal out was a bit of a rodeo, as I didn't have a puller or a slide-hammer with a hook. Ended up just...
-
TTractorTech replied to the thread Ford 5000 power steering. To repair, or update?.I resealed/rebuilt a 4500 not ling ago that yses the same system. I can't remember how I got the tapered pin out, but it was something...
-
TForty series SLE tractor wiring diagrams are in multiple pages. Some are in the electrical section of the service manual, some are in...
-
TTractorTech reacted to Cycledude's post in the thread Sthil Commercial Line Trimmers with 4 Cycle engines (still require 50:1 fuel/oil mix) - any experience with Good Post.
Interesting comments, how much line do you usually load into your Stihl heads ? I usually do about 12 feet but it definitely seems like...
-
TTractorTech replied to the thread Sthil Commercial Line Trimmers with 4 Cycle engines (still require 50:1 fuel/oil mix) - any experience.Well I'm used to the Autocut on my Stihl KM110 as you load the two lines, then just push the lines through the slots and snap in place.
-
TTractorTech replied to the thread Ford 7740 help. Please..Welcome to TBN! Yes, it does. #12 in the illustration.
-
-
TTractorTech replied to the thread MF 245- how full to fill power steering reservoir.Through the plug in the top of the can, #35
-
-
TTractorTech replied to the thread MF 245 -- can power steering fluid get into the engine crankcase oil???.Yes, through the PS shaft seal, #11 in the illustration.
-
