Recent content by troweller

So my tractor won’t start after replacing the battery. I was jump starting the tractor without a battery, using my truck, now I can’t get any signs of life on the tractor. I also replaced a fuel line. Any ideas?

I found a rats nest in my kubota, I was wondering what these fuel lines are for?

just got a flat tire, air and water were leaking out of the valve, what should i do?

i am planting my cover crop ASAP. i am using a broadcast cone spreader, how fast should i be driving? i have a Hydrostat, i am thinking High gear, PTO @ 540rpm

i have a new splitter that is hooked up to the rear hydraulics that i use for my BackHoe or TNT on my Kubota L3010. the problem is that the cylinder only extends outwards, and does not go backwards.

with all this talk about discs and rototillers, people with small tractors should know that there are real discs out there that actually do a great job. I am super fired up on this 4 foot, pull behind, offset bad dog, because it has transport wheels,brand new blades, really cuts deep, and has...

it's time to change the hydraulic fluid on the tractor again, which i have done before, my question is what should i do about the implements that have fluid in them? such as loader, which is on the tractor, and backhoe, TnT, hydraulic lift disc, and potatoe digger, which all have fluid in them.

I am rebuilding a JD #44 plow, 3 point, 2 bottom, and I can not find plow shares. The JD dealer is having much luck for finding "DEERE BC 250." Can anyone find these?

i have a JD #44 plow, 2 bottom, 3 point, that needs new shares, the old ones say 'Deere BC 250". i took it to a JD dealer and had no luck. any suggestions.

slowly rebuiding an old offset disc. I ordered new discs and the hole where the 1 1/8 " square axle/gang bolt goes through the disc is 1/8" too big. The guy at the shop said that is the way it is supposed to be sloppy, but the old one's fit snug. I need some more clarification that the discs...

I am trying to rebuild a old 4 foot offset drag disc with hydraulic lift wheels. I got the end nut off the axle and one disc off. Do i just knock the axle with a block of wood and a sledge?

just got a great old rusty offset disc that needs a rebuild. how do I get the blades off.

this is the first time that I have tried to change the hydraulic fluid in my L3010 hst. I am having 4 problems. 1-I can't get the rear drain plugs on rear axels off. 2-I can't find the strainer, I had TNT installed, I does the strainer have a picture of a book on it. 3-I can't get the...

1 1/8\"cultivator clamps I have a farmall Cub tractor with a belly mounted 11/8" diamond toolbar. Where can I get some cultivator clamps?

What is the maximum width between the rear tires on the Kubota L3010? I know there is 48" on center, currently 52" on center, and there are two more, but do not what they are. I can't find my book. At the current 52" spacing, there is about 20" between drawbar and inside of right tire. I...