Recent content by vortechf150

  1. V

    Side hydraulic brush cutter

    Has anyone built one? Kind of like a limb ninja, but I would rather build one, cheaper, and have a brush cutter already to use. Running with a hydraulic motor, has anyone done this, cutting fence rows of overgrowth, vertical cutter, but the ability to angle it to mow a ditch line. Mainly need to...
  2. V

    360dtc starter wiring

    Have a 360dtc I bought in 2006. I just replaced the starter, took awhile to get, but I see there is a black with blue traced wire with a "+" white sticker on it. Can anyone tell me which side of the starter does it go on? I think I remember that it goes on the stud that also has the main red...
  3. V

    Fence post drivers-gas powered

    Has anyone ever bought a gas powered tpost driver? Skidrill makes one, it's on YouTube, just want to see what are peoples recommendations on this, thanks in advance
  4. V

    automatic post drivers

    been looking at post hole drivers, pneumatic and motor operated. was looking at skidril, Gas Powered Post Driver $995, Post Driver, T Post Pounder, Gas Powered T-Post Driver, T-Post Driver, Gas Powered Paving Breaker, T Post Pounder, Picket Pounder, Gas Tie Tamper, Gas Tamper, Gasoline Post...
  5. V

    Needing exterior parts for 360dtc

    I am in need of a grille for a 360dtc, the piece with the headlight section, that bolts to the hood, and holds down the hood assembly to the latch. Also, in need of the grey plastic piece that attaches to outer piekce of fender, the flaring on the passenger side. I would appreciate any leads you...
Top