Recent content by vtmbz

I snapped off my pto shaft on my b7100 and now I begin to think the reason why was because I never adjusted my pto shaft to the tractor when I bought my brush hog. I drove over a log, it raised the BH and the pto snapped. I fixed it taking advice from this site, but then realized I never...

Here are the photos of my plug- I begin to see where you were going with this. A simple plug would have been more to the point. I think the dealership figured the groove in the fitting would suffice for the outport, but if I understand you, it didnt! I will try and find a proper plug today...

I dont know is this is how to upload a photo, but if so, this is my valve as it is installed. The port facing the tire is marked BYD I have a plug in it. It hose marked OUT is visible; the other end of it is by the gearshift lever and goes to the site of the fill plug.

I replaced my old 2 spool valve with a new eaton 31922. It works fine but squeals when not in operation. This is a KB 7100 tractor . To operate the loader you pull a lever under the seat back. WHen I do that, I hear a squeal. In lift or curl, no squeal. Eaton says this is an open center...