I need a cap to cover my pto when not i use. Any idea where I can find one? I have seen them before it is just a cap that screws into the back of the tractor.
I have a shibaura s700 4wd. I bought new wheel bearings for both axles in the front. I pulled everything off and it was no prob getting them off. Now I put the bearing on the shafts and cant get either side back on the top spline shaft will not go in for some reason the inside of the knuckle...
I cant get the 4wd to engage. The lever is loose could it be something inside? Maybe some kind of clip holding the lever and it broke? The lever just flops back and forth and will not catch on anything. Any thoughts would be great. Also if it is something inside how will I go about fixing it?
I live in VA. I would like to know about how much it would cost me to have a contractor pour a 36x26 slab and just frame the walls trusses rough in the pluming in the loft. I will put the shingles on and the siding. All I need is all the framing done. Any thoughts?
Does anyone know where I can find the parts to make a pull behind leaf vac? I need the part that hooks onto the motor. I have the engine and the cart just need the tubes and the suction device.
I have a pre fab wood fireplace now. I just ordered a regecy I1200 wood stove insert specifically designed to go inside of a prefab firebox. Has anyone had any experience with doing this? I spoke with the guy at the stove place and he said the insert is designed for this. He will put a new...
Has anyone ever tried to pull up a old aspualt driveway with a box scraper using the teeth? I have one in my front yard going to a old barn that was on my property the driveway is really thin and crumbled up.
I just wanted to get some thoughts about my new building. I plan on setting 6 6x6's for a 16x16 shop. Once the post are set I was just going to frame up the bottom of the post with 2x6's and poor concrete for the floor. Has anyone had any experience doing it this way? I have ordered the...
I have a Shibaura S700 4wd. the front wheel bearings are shot. The reight front I can take the wheel and move it with about 1-2 inches of play when the tire is off the ground. Does anyone know where I can find a new set and also is this the same tractor as a ford 1300?
I have a cast iron briggs engine 6 hp. I recently rebuilt it, before I rebuilt it I put a new magnito and points and a condenser on it and it ran and starter great. Now after the rebuild I cannot get a spark out of it? I re-gapped the magnito today and still nothing. Any ideas what could be...