Windblown's latest activity

Check every bolt. I had some loose cutters, a couple main bearing bolts weren't very tight, and one grease fitting wasn't even finger...

Ropes with lots of stretch are great for climber fall arrest or using a rubberband effect to pop stuck vehicles out of mud but I'll...

A simple digital angle gauge provides an excellent reference point to check assemblies and is useful for a variety of tasks. I use one...

You've gotten some good advice. The MS261 is a nice lightweight saw but running more than an 18" bar is going to slow things down...

Well I decided not to spray, too much prep and I was scared about overspray. I used 1 piece of plastic for the last 2 days of painting...

Personally I'd never use a sprayer to paint the exterior my own house. Brush or at a minimum roll and tip. As with any painting the...

Note wheel is plastic. It might be unusable after any lengthy exposure to any mixture containing acetone.

all 3 bolts show signs of slop hammering especially the one in the middle. You can see the mushroom where the collar meets the shaft...

As mentioned in a post above all the bolts in the photo show signs of getting hammered on their sides due to not being torqued down...

Got about 10 hours on the tractor in the last couple of days. Either running it thru a manual DPF cleaning cycle helped or whatever...

My Mechmax sg24 got delivered yesterday evening. Knocked out 5 oak stumps so far with it before moving onto to other stuff. It took a...

What's the verdict on using thin flexible fuel line for an impulse hose? I was having some intermittent running/starting issues with...

I can relate. I was bored the other day and pulled down a Stihl HS45 that I had picked up from my dads place 15 years ago or so. He told...

My solution was to decide it's not a lawn, it's a meadow...

A "weed" is defined as any plant growing where you don't want it. So by definition, if I'm OK with the stuff that's growing in my lawn...