Recent content by YukonKing

I do have chains I can put on the front as well. My hope was to run the rear H pattern V-bar and be able to run in 2wheel drive more often. Using the front only as steer tires or when I so get stuck. I will have my rear chains soon. Likely will have to add spacers but this will create a delay...

I'm waiting on my chains. Planning on spacers. Depending on how they fit and how far over the shoulder of the tread they come down. I'm just disappointed how expensive they are, after a fit-up I will decide if I can make them. If I can get away with 1" I will make them, but more than that I will...

Hey All, Anybody run chains on a L2501 with R4's and no spacers?

I was referencing installation instruction from an electric setup, but it must have been for another machine. I do have the connections as noted by Brian.

Another question, the L2501 has the power beyond at the rear of the tractor plumbed right back into the tank. What flow path or action would happen if you installed a closed centre valve? Would it be running then maxed out and push fluid through the pressure relief valve?... Just thinking ahead...

Yes! This is more of what my goal is. The tractor is such a good tool, power source, etc. I just want to make the most out of any change/upgrade.

I think the cost will be similar, just looking at locally available vs ordering online. And also looking at the options once I plumb into my power beyond port which is currently unused. If I do the work with my parts I can add a manifold for other valves like a top and tilt for the 3 point, etc.

So I have a 2021 L2501 with Loader. I opted out of the factory 3rd function at the time of purchase to reduce the cost. My plan was to install a aftermarket 3rd function myself, I see many options for the electrically operated ones. Have any of you installed manual "spool" valves? It seems...

Confirmed as 14 JIC, the solution is to build straight #12 hoses and they sell 14 to 12 adapters. All good. Next question. What is the little t handle in the bottom of the picture. it comes out and is just a long rod with a bent end. not in a fluid reservoir or anything.

Hey All, Anybody have insight on a Ford 5500 Backhoe hydraulic fitting? I blew my boom lift line. One end appears to be JIC 12 Female and the other JIC 14 Female. The 14 size seem to be an oddball. Unfortunately i'm up North and those that fix this stuff know less than I do, so I need to...

Hello All, I have been the owner of my JM254 new since 2007. I now have 500 hrs on it. I have had little issues and none that have needed research lately. My new problem is with the shuttle shift. I have adjusted it many times because it wouldn't engage in one of the directions with success...

will the oil from the axle housing run into the portal? this is after removing to change a short axle/hub thanks

Hi all, I have a JM254 with shuttle. Does anyone have the shift adjust procedure. I have a hard time going into gear.

Hi all, I am looking into this for a friend. Does anybody know if Jang Dong has a one cylinder engine? It's a diesel. Apparently it's a 2007 around 20 horse. Any other brand names that a fellow could look for parts under. I don't know much about it. Main thing is finding info about the 1...

Just for reference, digging with LW-06 jinma backhoe. They work.