Recent content by zilla24

Plastic

I am definitely going to pursue a replacement, great suggestion.

Appreciate the responses. I did some YouTubing and figured out how to check the fuel gage. Removed the instrument cluster and applied current (using a 9v battery) to the positive and negative lead on the back side of the instrument cluster. Then took a test wire from the tank sending lead to the...

Good evening everyone, could really use some help diagnosing my 3510 fuel gage. With 3/4 of a tank the gage will only raise to 1/4 at best. For those that have had a similar issue where might I start?

My 2005 3510 is a TYM build.

A easy way to tell the difference between the early and late is the sheet metal and grill. The “late” had a swooping rounded nose grill while the early were very boxy. Early also had a yellowish/tan rim while the late had silver. I have a 2005 late model with 1300hrs. It’s been an awesome...

Here are my remotes and the excerpt from the manual. It suggests holding the lever in push or pull position will cause the oil to travel through the relief valve and cause it to overheat. There is no detent on the lever or proportional valve that I can find. If I use a bungee cord will this...

Found a log splitter locally on CL and would appreciate a sanity check on whether my tractor can handle it or not. The splitter is a Speeco 400197 that runs off the tractors remotes, I would like to use it on my Mahindra 3510 gear tractor. From what I can find my tractor is rated at 6.4 GPM...

I’m having some charging issues with my old cub cadet model 86 with a 10hp Kohler. It wasn’t charging, with a meter hooked to the battery at full throttle it was outputting 12.5 v. I bought and replaced the voltage regulator, it is now charging at 16v! Is there an adjustment procedure I need...

Hello all, Looking for some help with my 2006 Deere 997 zero turn, I bought it used a few years ago and have accumulated about 2200 hrs on it. While its down for the winter I'd like to do some PM work, specifically adjust the valves. If anyone has some guidance on how to set TDC and how to...

Here it is. Quality is very good, dry run with no snow worked great.

I have a Pats quick change system and it’s working nicely with most of my implements. I decided today to check my snowblower and realized the PTO shaft is too short. Do any of you guys use PTO adapters for making up the missing 5”? If so which one do you recommend? My blower gearbox shaft...

For all of those currently using a Pats Easy Change Quick Hitch I have a few questions... -How do they respond to tightening the stabilizer arms on the 3pt? I致e always snuggled up on my adjustable drag links to minimize any float on my scraper blade or finish mower. I知 slightly worried with...

I've done a search and can't find any current information, does anyone know where I might source a grill guard for my new style (2005) 3510 that will work with the ML112 loader?

Rustoleum sunrise red: Krylon international harvester red: