zzvyb6's latest activity

Made my own using an ancient PU truck plow. Yes I have the JD QA plates, but the skid steer plates are cheap, then just add some pins...

Yeah, I forgot about the loose needle brake issue. That's the real need. If the plunger gets stuck by the stops, that's a sound the...

The 4 place snowmobile trailer with that hay bundle and axle positions gave me about 60 lbs of tongue load. That'a about 1/2 a tank of...

Yep. That was me in my Y2K 'vette. Standard Draw-Tite bolt-on hitch was readily available. I was being passed on I-96 by a blond in a...

Switch the couplings so that curl and lift are swapped. Then see if lifting the loader arms is a problem and curl is now ok. That...

Back down the ground travel, windrow size, or sharpen the plunger and stationary knives. There is really no need to get a slip clutch...

Ensure that the wire is being pulled from the correct spool direction.

I have a set which lets you flip it from expand to contract by moving the hinge pin. Weak link for me has always been the tips bending...

Well, new ones don't arrive dull. It's not done for the dirt, but for roots, weeds, grass, etc.

Sharpen the blades ! Grass isn't being cut, just pulled out by the roots. Also try backing into the furrow instead of going forward...

Be careful moving that load. That much mix + water + sand + gravel (or just the pre-mixed recipe + water), is VERY heavy. Have a lot...

I have a JD 1435 diesel, 72" front mower, 60" broom for snow removal, and I also can run a 540 rpm Winpower pto generator on it with a...

My local hydraulic shop is a lot cheaper than my dealerships. Remove it and have them duplicate it.

I don't think so. I recommend a 3 series with a loader. Even a previous generation 390. Power and weight gets you thru all the tasks...

Here's another example of an incorrect installation on a Kuhn combo tedder / rake. The photo shows the driveshaft's C.V. joint now at...