Search results

Bought tractor back in November. Needed service bad changed hydraulic fluid and filter. Just hooked it to 10 foot bushog - Lift will not pick it up. Did pick it up twice after much trying but that was it. Will pick up light equipment. Transmission mounted single pump. Operators...

Suggestions on good place to buy parts?

All fluids and filters changed. 3-point lift will not pick up heavy equipment - need pump rebuild? Inner rear remote raises but will not move forward to retract or float. - another rebuild? Thanks

Do need to run JD HX10 with chain to keep top roller out of bind?

Any ideas on best way to check out this problem?

Where is LPCS on 6610S? Have looked at every diagram - nothing matches mine don稚 think it has one. T

Servicing and repairing all the neglected problems has taken a while. I have a shop manu and an operators manual now. Both say to remove the low pressure circuit strainer and clean when servicing. Problem is I don稚 see it! It is supposed to be located beside the hydraulic screw on filter. My...

I致e tried turning black ring on housing at top of filter to no avail - didn稚 want to break it. See picture.

How do I quickly determine if tractor is emission controlled? Thanks

Default New Holland 6610S I owned a Ford 3000 for years - recently sold and bought a 2000 New Holland 6610S. Previous owner used very little and tractor hasn稚 been serviced in years. Trying to figure out what filters and other parts I need to replace. It seems these tractors had many little...

I owned a Ford 3000 for years - recently sold and bought a 2000 New Holland 6610S. Previous owner used very little and tractor hasn稚 been serviced in years. Trying to figure out what filters and other parts I need to replace. It seems these tractors had many little differences. My questions...

Ford 3000 - Hydraulic line assembly from pump to housing. The steel lines go from pump on left side under fuel tank across and down under foot rest on right side where they bolt to housing. The high and low pressure lines are in one assembly. First problem -- due to age high pressure line...