Search results

I was using the bucket on the tractor and the controller when loose, one of the balls that lifts the cable came a drift. I rang the agent who sold the unit and they said have to buy whole thing for $550 they and I thought this was over the top. The bucket is made by Challenge Implements for CNH...

I just bought a Kubota BX2670 and had the rear hydraulic kit fitted. The kit provided 2 sets of rear outlets with controls that spring back to the centre. I want to vary the amount of flow to change the speed of a hydraulic motor on an attachment which also uses the PTO to turn a screw. The...

I want a tractor to drive between raised beds that will have blue berries growing on them. The narrowest I have found is the Kubota BX2370 at 1130mm (44 1/2") this is a bit wider than I would like. Is there a way to reduce this with tyres or rims? Or is there a narrower alternative? I want to...

I am trying to make raised beds to grow blue berries some at 3m (10') and others at 2.4m (8') centres. I have got the use of a merbein plough and set it at 2.4m which is as wide as it will go but at this width it does not move the soil to the centre. I was thinking if I made some sort of shaper...

I can't lower the 3 point linkage on a 100Hp International Case or CNH International SA it was made in the UK. If have read a lot here and elsewhere about a control below in front of the seat. The only controls near the seat I can see are to control the seat. It has 2 leavers to raise and lower...

There are 4 hoses going into a FAST brand connector 2 banks of 2 and I have no idea how to disconnect them.:confused: