Search results

I've got a diesel gator 6x4 with a worn out secondary clutch. I bought a new clutch but I can't get the old one off. It has a cap screw on the end, manual says it has left hand threads - it's stuck on so tight (trying to turn it clockwise) I'm afraid I'm going to twist the screw off then I'll...

A farm worker ran my 6x4 diesel dry. After refueling, filling the fuel filter bowl full and pressing the lever on the fuel transfer pump hundred of times, it still will not start. Obviously starved for fuel. What else can I do? The technical manual says that the system is self priming but the...

Does anyone know the engine oil capacity for this tractor when changing the oil and filter? Also, does anyone know where I can get an engine oil dipstick for this tractor? Thanks Kdoregon

My JD 318 shredded the front PTO belt and took out the wiring. I'm left with a blue wire hanging from the bottom of the PTO, a white wire up at the top right (passenger) side that was completely shredded. Also a blue/purple wire coming of a rectangular device to the right of the PTO. Anyone know...

Does anyone know where the wires to the temperature sensor are located on the JD 4310. Just got on my machine today and the guage is stuck on the low end pin, does not move even slightly. I'm thinking the wire is disconnected or broken - as my Gator problem of last weekend was due to critters...

I've got a gator, glow plug lights gone out and it won't start. I've replaced the glow plug relay and the ignition switch, still won't start. Turns over fine, but acts as though no fuel, with tank full. Any ideas? Thanks

I've got a gator diesel, the glow plug light will not come on (thus it will not start). I've replaced the glow plug relay and the ignition switch, but still no luck. It turns over fine but won't start - midday, when it's warm, the engine will fire briefly but will not continue to run - any...

I've got a gator diesel, the glow plug light will not come on (thus it will not start). I've replaced the glow plug relay and the ignition switch, but still no luck. It turns over fine but won't start - midday, when it's warm, the engine will fire briefly but will not continue to run - any...

I've got a gator diesel, the glow plug light will not come on (thus it will not start). I've replaced the glow plug relay and the ignition switch, but still no luck. It turns over fine but won't start - midday, when it's warm, the engine will fire briefly but will not continue to run - any...

I am reconditioning my JD 111 while my JD 318 is in the shop,. The deck is off right now but I noticed that with the engine running, the PTO pulley is spinning - regardless of whether the switch is on or off. As a matter of fact, if I get off the machien with the PTO switch in the on position...

I sent my John Deere 318 to a local dealer for service after a winter in the barn. After 3 trips back, the tractor is all but unusable. At full throttle, once the PTO is engaged on a slight incline, the unit backfires and sputters to no end. The only way it will operate at all is at a slow crawl...

I sent my John Deere 318 to a local dealer for service after a winter in the barn. After 3 trips back, the tractor is all but unusable. At full throttle, once the PTO is engaged on a slight incline, the unit backfires and sputters to no end. The only way it will operate at all is at a slow crawl...

got my 318 out of the barn recently, would not start - just clicked. After researching here and elsewhere, I replaced the starter solenoid, the battery and bought the JD solenoid booster kit. While installing the booster harness, I noticed the white wire to the oil pressure sensor was off...

I've got a MT372D, needs PTO shaft installed. I've got the parts, have removed the seat, rollover bar and fender bracket. It appears that I now need to disassemble the top end of the rear hub. How is that done? I.e., what is the sequence of parts removal to get access to the inside of the hub...