Search results

Does my loader have the float option? Is it something I can add if it doesn't. The boom lift valve looks much longer than the bucket trip valve but when I press all the way forward, the lever stops and doesn't lock in. It looks like the spoon has rusted and there's an extra 1/2 inch on the...

I have a 1975 Ford 3400 with the wonderful Holley Carb. I have been struggling with it lately. When im going down a hill or the load lightens on the tractor, the engine revs. I throttle down and it will hold at that RPM. Any time there is a large change in load on the tractor the governor...

I have a 1973 Ford 3400 with a loader. I use it for all around house hold chores. My front tires are passenger car tires. They are rubbing on the spindles and one has worn to the point it is now leaking. They are very bouncy when it comes to loader work. I am looking to replace them with...

I just finished up splitting my oliver super 55. I put it all back together and now need to adjust the governor. I read my operators manual and it says to put the throttle at wide open and remove the governor adjuster rod from the governor lever and adjust the governor adjuster rod 1/16 ahead...

I was out skidding logs and my gear driven hydraulic pump (rock shaft pump) began leaking. It was the small tube (high pressure) side. I couldn't tighten the nut so I took it apart. It's a crush type fitting. I ordered part c7nnh856c. The part came in and what I read on this forum, was that...

I'm going to exchange the fluid in my 3400s loader. I would like to get as much fluid out as possible because I have water in the hydraulic fluid. Any tips or tricks to get the most fluid out? I know there is a paper filter and a composite filter. Is one better than the other or should I...

I bought recently bought a Ford 3400 The previous owner replaced the starter and solenoid. I changed all the fluids and did all the maintenance. I went to use it to move some rocks the other day and it would start and run with the key in the crank position but it would die as soon as I...

I blew the PTO clutch out on my Oliver Super 55 when brush hogging. I split the tractor replaced the PTO clutch, some seals, and the pilot bearing while it was apart. I am putting it all back together and I am struggling with the wiring. It was converted to 12v neg ground at some point. The...

I have been working on my new to me ford 3400. I'm going through all the maintenance and fixing anything that needs it. Today I found that the govener arm is falling off the carb. I pulled the arm out and the clip is broken. I can't find any parts online. I'm going to check the hardware store...

I just purchased a new tractor for my house. After a lot of research and budgeting I settled on a Ford 3400 Gas with a 730 loader. I found a 1965 gas job that looks like it has very very low hours. The tach fell down over the hour meter so I don稚 know the actual hours but the tractor looks...