Search results

Hello everyone, I just wanted to be 100% safe with my 4wd..can someone confirm that these are the proper tires for my tractor. Kubota L3130 Front : 27 x 10.5 - 15 Rear : 44 x 18 x R20 Thanks a bunch

Hello everyone, I just installed a block heater in my L3130. For some reason, my coolant reservoir does not have a line coming out of the bottom...just an empty nipple. The radiator has two big lines (one on top/one on bottom)...a small line from the radiator cap which goes to the reservoir...

Hello everyone, I'm just starting to use my first tractor...a Kubota L3130. I dug out a stump the other day and then tried to lift it out of the hole using my LA723 loader. Chains setup directly perpendicular (underneath) loader back/mount plate. Tractor wouldn't do it. I dug a ramp pulled...

Hello everyone, I bought my first tractor over the winter (2004 L3130 Manual 4x4 - 2k hours). Seems like I might have made a bad choice. I just found out that my serial falls into the tractors affected by PSB 2004-055. I attached the bulletin. Apparently when operating the backhoe (BH90 for...

Hello tractorbynet, I have the front axle hub apart on my L3130 (4x4). I want to replace the seal that goes between the hub (part with lug nuts) and gear/knuckle housing. The part # is 34070-13370...I attached a diagram, it is 060 or 180 on it. It is basically two parts...an outer rubber seal...

I'm rebuilding both front axle knuckles right now. Figured I would research this topic before I put it all together. Seems like a lot of people support the idea, and of course some say it would have come from the factory that way if it was suppose to have it. So, I'm on the fence a bit but...

Hello everyone, Just picked up a used L3130 with 2k hours on it. It's been running dino oil it's entire life. I've been taught that switching from dino to synthetic so late in life is not the best (prone to leaking) but I would be glad to hear conflicting opinions. I was planning on buying...

Hello everyone, I tore down both front knuckles on my Kubota L3130 (2k hours). Both front bearings were shot. I was amazed how little damage there was. The bottom bevel gear (TD030-13200) sustained almost all the damage. Do you mind taking a look at the picture and telling me what you think...

Hello everyone, I just bought this tractor. It is completely new to me. It had a leaking seal so first thing I did was pulled off the front knuckles. When draining the fluid it had a fair amount of flakes in it. All were every small. I just wanted to get some advise on how to handle this...

Hello everyone, Willing to drive to pick up new tires for my L3130. I currently have R4s. I'm happy to keep them but would also be willing to do others. If anyone has any or if they know a place to get them at a good value I would appreciate it. -J