Hello everyone, working on my JD 2240 today . Putting the bushings in the rock shaft lift arms. Just wondered if any one else has ever done this, and if the new bushings took the play out or if the shaft may need replaced.
Just have a question on a 2240 John Deere . Could the steering valve assembly leaking cause the independent PTO to grind on engagement. Thanks for any answers.
I have a JD 2240. Just installed rear crank seal from JD. Put a little oil on seal on installation. Has a small leak. Just wondering if this seal should have been installed dry. I used proper install tool for the seal. Don't know why it would be leaking, any help appreciated.
Hey TX Jim, Having a issue with my 2240 rear crank seal. It had a national oil seal in it, rubber lip seal. Installed a JD seal wear ring seal combination and it still leaks, crank journal looked good. Any ideas
I have a JD 2240 , Trying to adjust 3 point hitch. Took out 1/2 drive plug by selective control lever. Adjustment screw inside there won't turn, anybody know why this wouldn't turn. Appreciate any answers.
Just have a question on my 2240 JD. Trying to adjust 3 point hitch. The plug by the selector switch you remove , that is 1/2 drive the adjustment screw inside there won't turn. Anybody have ideas why this wouldn't turn.
I have a 2240, Replaced hydraulic fluid a couple months ago for loud metallic rattle, also filter and cleaned pre - screen. Screen was very dirty and fluid also. Noise is coming back. Could screen be clogged again
I have a 1980 2240 with Hydraulic pump noise after starting tractor takes a minute or two for noise to start very loud metallic rattle eveything works noise stops for a second upon engaging pto seems like cavitation can anybody help would appreciate any help thanks