Search results

Hi all. I have an LS MT125 that I am reassembling after rebuilding the transmission. I bought the tractor partially disassembled with a lot of parts in buckets. For the most part it's going well, but there are these two rubber items that I can't figure out. I've looked all over the tractor and...

Hi all. I have a MT125 that I am reassembling after rebuilding the transmission. I bought the tractor partially disassembled with a lot of parts in buckets. For the most part it's going well, but there are these two rubber items that I can't figure out. I've looked all over the tractor and in...

Hi everyone. I have an LS MT125 that I got for cheap. The problem is the transmission is in very bad condition. The previous owner hit something with the hydraulic oil filter (no guard installed) and ran it out of fluid. Then kept trying to make it go until it started making very bad noises...

Hi everyone. I have an LS MT125 that I got for cheap. The problem is the transmission is in very bad condition. The previous owner hit something with the hydraulic oil filter (no guard installed) and ran it out of fluid. Then kept trying to make it go until it started making very bad noises...

Hi, I have a CG2310 that needs front tires. I managed to get the existing tire off the wheel and the wheel is very rusted. Completely gone in some parts of the rim and very thin around the bead. I've been trying to source a new rim, the tire size is 18x8.50-10. Does anyone have a good online...

Hi Everyone, I thought owners of old MF GC2310 tractors, and other models too, might be interested in this project. The steering cylinder and tie rod ends on my GC2310 are shot. I tried getting the cylinder rebuild here in Hawaii but wasn't encouraged by my investigation. Just for grins I looked...

Hi Everyone, I'm the new owner of a very rust GC2310 TLB. I bought it for a cheap $500 mostly just so I could use the backhoe arm and hydraulics to build a small tow behind backhoe. But if the tractor can be made to run without spending too much $$ I'd rather just use the platform as it was...