Search results

I thought I had read somewhere that loose wheel nuts cause a creaking noise but I can't locate that thread anymore. This has been happening for a while. Not sure when it started. I have the wheels bolted on at the widest possible setting. I tried tightening the wheel nuts but the noise...

Anyone know how to use one of these? I believe it is a silt scoop but the person I got it from hadn't used it and doesn't know how its used. I am hoping I can use it to maintain some dams that have not been cleaned out for a long time. Anyone got ideas as to how to use it?

Anyone got a bolt on or weld on mechanical thumb (non hydraulic) on their jinma JW-03 backhoe? I would like to know if there is one ready made to suit or wether you made one and your experiences/advice.

My backhoe is leaking from one of the curl function hose joins behind the boom cylinder where the hose connects to the hardpipe. The trouble is i cant even get my hand in there to peel off the cable wrap to confirm if the joiner needs tightening or its the hose. Anyone had experience getting to...

Yet another problem. Tractor started. Was warming it up. I tested the lights. Most were working then suddenly the headlights flickered and died. All lights and instruments lost power except the ampmeter. Turned off the tractor and as expected cant start it. No lights, instruments or crank. Does...

Can someone please tell me where the black loose wire with the round connector which is hanging over the engine label is supposed to go.

My 2006 254 has been hard to start since i bought it a few months ago. It used to start after until accidently leaving the fuel tap off and running out of fuel. After repriming It then would not start at all and produced lots of white smoke which i believe may be unburnt fuel. The only way i got...

If anyone is looking at doing this i managed to do it without any drilling or welding or using any bracket. Assuming you use the same filter assembly as below or one with similar width mounting holes it is possible to mount it using threaded rod and 3 nuts per rod. The rod goes into the block. A...

FEL suddenly stopped working. Power steering still works. Fel moves a little when i turn the steering wheel. No previous issues with fel but i have not owned tractor long. There is no strainer in the hydraulic tank with this model. Oill levels are correct. From what i have read on this forum i...

Just wondering if anyone has knowledge of the old Psquali tractors, my clutch works but it bites too soon, probably less than an inch from it being fully pressed down. Other than that its a tough little beast, the lombardini engine fires into life instantly every time. I'd like to eliminate a...

I have a Jimna 254 with 150hrs on it that I haven't owned for long. I have not used the PTO under load as yet. I have had an issue with the PTO spinning all the time. I sorted that issue out by adjusting the clutch as described elsewhere. The PTO engagement lever down by the right foot works...