Search results

Hey everyone, I need a little help again. I have a 9250 backhoe attachment for my loader and it has a leaky stabilizer cylinder. So I got the kit to replace all the seals but I'm having a heck of time getting the rod out of the barrel. I believe the barrel is a AU40410 the rod is AU40413 (my...

This picture shows the left side of the front hydro pump. I if I remove that 1/2 bolt from the top is this where I will put my new hydro gauge? I was worried that this was some type of a adjustment bolt for the pump. I removed the 1 1/4" plug from the other side of this bolt but those threads...

Hey everyone, I need some help. Have a 1971 JD 401 and when I use the loader the motor wants to stall. I parked the tractor about a month or so ago and when I parked her she was running fine. The motor fired right up on a quarter turn just like always when I started her this week. I raised the...

Hello everyone, I'm looking forward to learning alot from the site....

C4Ranch, I did run it in the hole hoping it would just spin but it seem to just get tighter. I was very careful in doing because I didn't want to split the drive shaft in half like I did with the grade 8 bolt as the shear pin (as you can see in the pic). It seem like the drive shaft pushed all...

Hey Everyone I need a little help, the shear pin on my Post Hole auger did its job and sheared but now the drive shaft is stuck on the shaft of the auger head and I can't remove it to replace the shear pin. I've tried to use chisels and wedges but with no luck anyone have any ideas?