Search results

So after a long wait I finally had my clutch replaced. the old one with only 300 hours was a real mess, Most of it I'm pretty sure due to my driving, however the mechanic wasn't sure that maybe something was loose. Since I purchased it brand new, only one to drive it, never had it apart, I...

May be having some problems with my mechanic so looking for the flat rate hours to exchange clutch and pressure plate on My New Holland 2005 Tc40A always garaged so a clean take apart. Most of what I have seen is from old posts and varies so the actual suggested time would be very helpful if...

looking around the web and can't find a clutch alignment tool for this project, Should be 16 splines 9 1/4 disk diameter hole is 1' 1/16 may be off by 1/16" for a SBA 320040930R clutch This is aftermarket # Understand it can be done without but need to be sure. Thanks

looking around the web and can't find a clutch alignment tool for this project, Should be 16 splines 9 1/4 disk diameter hole is 1' 1/16 may be off by 1/16" for a SBA 320040930R clutch This is aftermarket # Understand it can be done without but need to be sure. Thanks

In need of new clutch and left on my own to order . Looking around I am finding generally $250-$275 should cover my need for clutch, pressure plate, and bearings. Then I came across Partspring and see only the clutch is over $600.00. So wondering if the high price is OEM,that much better...

So I purchased this tc40 new and all went fine until now. clutch is shot and I need to replace parts. Alway was aware that I purchased A TC40 and left it at that now as part numbers become critical, on further investigation I find I have a TC40S4 serial G525382 , so checking on the net to see...

Been here before with the same problem, as have many more on this site, pulled wired connections I could get apart used dielectric grease then switched the battery with a known good one, took old tractor battery put in truck and its been fine ever since and the tractor started with the truck...

So I致e been bitten by the clicking solenoid bug and have searched far and wide for a solution and need one before I screw up everything. No signs of problems ever, then the other day tried to start and only a click. Trickle charger shows green, been on all winter, old battery tester reads good...

So posted earlier trying to figure a fair price to replace clutch in my New Holland TC40 though not any answers to the going price I now find that a new flywheel is considered as part of the job. I find this to be unusual as I have less than 1200 hours, the clutch is not sticking, and the...

This has probably been answered a million times, but since I don't have the answer I will ask. I have a New Holland 40hp boomer, year 2005 and it appears the clutch is worn and needs to be replaced. since I live in a remote area (island in fact) the cost to trailer the tractor is very expensive...