Search results

High humidity with air space in the tank creates water in the tank from condensation. I have less problems when I keep the tank near full during storage times.

Thicker gravel bed needed

A master grader blade will be much more suitable. Box blades were designed for moving material more so than grading a hard roadway. Weight is critical. Once a rub board condition is created, it must be cut out to eliminate it. Filling in the waves with loose materials won’t fix it.

You dealer should be able to answer why not question in clutch my 45 hp John Deere has a built in clutch and my 6’ rotary cutter has a slip clutch as well. Most exposed slip clutches rust and no longer slip anyway unless frequent maintenance is done. That requires loosening the bolts and making...

It depends on the type of work. If you blow snow or bale hay or use a rotary cutter mostly a cab will be great. Intricate grading dirt or crop tillage where you need to see , the cab isn’t so good.

I have a 14k TopHat and have hauled 7 loads in one day with no extra charges needed. tons of uses for a dump trailer. it doubles as a utility/ equipment hauler. I also have a solar charger connected so I never have to plug in to 120 volts.

If it is a hydrostatic transmission check for the optimum rpm for the engine while working. If the Rpms are too low the hydraulic pump will not be pumping enough fluid for it to operate correctly. Will it operate at low rpm? Yes. Will it operate correctly in a high demand situation? No. that...

Once you become in tune with your equipment, you are going to know when it gets tire light. Keep the clutch covered. once the rear tire lifts it will loose traction and the machine will tilt until it reaches the stop block on the front end or the bucket touches down. probably a job for tracked...

They make low profile tractors for work inside chicken houses. Ideal for low center of gravity. 4wd is a must. Water will freeze but antifreeze can be added to eliminate that drawback as a form of ballast. skid steers have wide variety of attachments and a very low center of gravity...

You can use a multimeter or test light to check for leaks on cables and connectors. usually heat build up is resistance. if your positive cable is getting hot put your multimeter leads on each end and see if it’s showing voltage.

If you can roll it with your fel it will help knock the dirt off so it will burn.

I have a few with the pin short enough that the circular keeper doesn’t stop on the pin, it passes it and the keeper lays flat against the implement. This lessens the chance of something getting behind it. It does make them more difficult for you to remove, but that what we are looking for...

Cut low and grind it or burn it. Burning attempts harden it and keep the insects away so rot will be hindered.

Place them in the trailer then dump dirt or sand in so they can’t roll. Or build a crate out of plywood.

Starving for hydraulic fluid

Get a zero turn

Wheels spin or not, clutch fully depressed or foot completely off was the way my grandpa taught me.

After some issues with starving for fuel after replacing the primary filter and checking for flow at the tank, I traced the fuel line and found an inline filter located between the steering wheel and valve cover. This required removal of the hood to change it. I知 sure it was easy to install...

I recently had the pin hole for the right lift arm fail on a 2004 john deere 5105. Has anyone else had this issue. I am in the process of replacing the right axle housing with a used one. Does anyone know the torque for the bolt in the end of the axle and the torque for the axle house retaining...