Search results

Cheers for the advice so far. Given me something to think about. :)

New house build and after it I have a 1.5 Acre site to sort out. I need to break up compacted ground for planting grass etc. Some of the compacted ground is bare earth I leveled recently with an excavator and some has rough grass on it I want to reseed. There are plenty rocks in the soil round...

Had a look at Grizzly bars just now, I see what you mean. No vibration motor required.

Cheers, I did toy with the idea of making my own. Seems you can just buy some heavy weldmesh, a vibration motor and some angle iron for a frame and your in business. I can weld so would be doable. Will have a look on line to see if I can copy a nice simple design. (y)

Hi - I have about 200 tons of top soil (in old piles) I want to screen after a house build. It varies from good quality top soil with some small rocks (inches) to other stuff which has a lot of rocks in it up to maybe up to 12 inches diameter roughly.What I want is to get the rocks out and...

Hi, after having a close call nearlt rolling over recently and living on a hill side I thought I'd adjust the rear wheel track to full width. Checked the Manual and its a little cryptic "change the tread to the desired position" after undoing the bolt holding the wheel on. Photos attached...

So I have a Kubota B2230 with a recently added front loader. The problem I have is because my tractor is the cabbed model the top grease fitting cannot be accessed. There is an access hole but you can only use it if you detach the loader. I dont want to have dettach the loader to be able to...

Hi Newish operator, I need to move 75+ton of dirt in piles of about 10ft high. Its been sitting 10 years so is very well compacted. I attacked it with my Front loader (Kubota B2230 HST) but was strugging to break into it and get a full bucket. I need to move this dirt about 100 yards for...

So I have a B2230, and I have a LA332 FEL on it with a bucket. I also have a 3 point linkage set of pallet forks for the rear. However they dont lift high enough (barely 2 foot) to allow me to load pallets onto my trailer, which I sometimes want to do. Im assuming the best approach is to...

Recently bought a box blade online, described as having curved rear cutting edges but now it's delivered they are actually flat plates angled at about 45 degrees to the ground. Not tried it yet but seen online everything attachments saying the cutting edges should be curved for soil work and...

Just bought a used Kubota B2230, now I get it home and start going over it I am getting worried. Firstly it wont shift range (lever low,med neutral and high) when the engine is running. Grinding noise if you try too. I seems related to the hydrostatic controls because if press the hyro pedal...

Hi I just finished building a house, now I have a 1.5 acre area to transform into a garden, a garage to build, drive way to put in and drainage ditches to put in on a sloping site. I have big piles of dirt that need to be used to contour the place as well. I was thinking of getting a used...