Search results

When I turn it on it just starts dumping hyd-fluid from that same spot pictured. I can't drive it as the hydrostat trans --> driveshaft (I'm presuming here) has no power... (no spinning shaft at this point) BTW it only has 452 hours on it. But then again w/ equipment, it's just a matter of...

Thank's, I'll look bearing seals up as a starting point / when I talk to my nearest Kubota dealer. If it was your rig & you wanted to DIY it - how might you proceed?

I picked up a f3990 yesterday at auction; mowed on a steep grade sideways for about 3-4 minutes & noticed the PTO lost some umph. Drove it down to my driveway & while I was looking under it, it just started gushing from underneith. Haven't fully investigated yet - will have to get the larger...

BTW, the little NH TC40DA did admirably with the big heavy duty round bale grabber that I bought at auction a couple years back... Not sure of the weight, however, it came off of a 100+ hp tractor & I adapted it to fit JD top hook & pin system. With this little NH skid steer quick attach there...

It would be really appreciated if anyone had some anecdotal experience / thoughts on the following... (NH T4.75 Tractor pre-emissions 2012 - NH 655TL loader etc.) - NH mechanical 12 shifter ~ (with the power reverser / shifter on my recently deceased JD 5065e I never broke myself of the habit...

Thanks @ 'oosik' - that is a nice looking tractor & VERY impressive front grill guard (I'm taking note) ! I like the grappel attahment that you have, however, I will be initally going with what I just lost... Titan from palletforks.com. This prarticular grappel has met & exceded all my...

I just want to say 'Thank You' to all of you on the forum! I really got a lot of good feedback and advice when buying my NH TC40DA. So I have a $1000 dollar deposit on a 2012 NH T4.75 with a 655TL loader (open station) 240 some hours! I'm probably one of the few that specifically does not want...

4' x 5' bales that I have been dealing with, moisture makes a big difference & my "bar" is lifting it over my round bale hay feeder. Some of these heavier ones I have to give it the 'momentum' UMPH back and forth while the hydraulics are lifting to get the loader arms up that high... BTW...

Congrats on your purchase... I would be tempted to put that piece of tractor machinery away as an 'artistic' appreciation relic... it is awful pretty in that nostalgic sense, lol... grey and red ~ very nice looking rig!

Good advice... Fortunately this tractor seems to be a needle in a haystack find. I'm thrilled to have gotten a 2007 vs the alternative of buying something new; for a host or reasons, lol... I hooked up my 6' Woods finish mower (will try out my 7' mower on it tomorrow) & really came to enjoy the...

I know this is short notice but if there any suggestions on things to look for in my pre-purchase 'once over' I'd appreciate your $.02... The Tractor looks 'mint' with just under 600 hr's. Primarily I would like to tease out any transmission / cruise control issues (its a hydro) & I have NO...