Search results

Following up on my results ... The Deere 239 timing pin (flywheel) is at tdc. So this motor's pump is timed to 0 deg. The 188D case i worked on was timed to 8 deg btdc. Both motors are running well currently. I'm no expert but 30 deg sounds wrong to me. I've had some feedback that the compressed...

Can anyone answer this .... Instruction to set Injector Pump timing says... (general desc.) 1. Set to TDC #1 cylinder (compression stroke) 2. Insert Locking Pin into flywheel 3. Remove Injector Pump side plate to validate timing marks are aligned. If not, rotate pump housing to align. Q. If...

Case Backhoe 33 - Control Valve to Manifold hoses (x4) - p/n D42601 - 18 1/2" Long. I have to replace a couple of these hoses and I thought I'd do all 4 while I'm at it as the others look a tad 'ratty' also. Apparently, there are only 4 of these in the entire US currently (11/25/2019) and are...

I am not a diesel mechanic and am helping a buddy with this project ............ Have older 580CK and recently had the injector pump rebuilt (Roosa - advance ring broken up) Now have a lot of crankcase pressure. I was unaware about 'Timing' the pump so just put it back rotated as vertical as...

Got an old 580CK which had a problem starting. Following repeated attempts to start it, and using a lot of ether, we found out the injector pump (Roosa DB2) had a problem. (a usual 'ring' problem we understand) Got the pump rebuilt. When running the motor now, the dipstick & cap blows out part...