Search results

I purchased both a front plow and a snow blower for the front of my BX25D a few years ago. I too clear about a half mile of gravel road in the winter as well as areas around my out buildings. I pack the first few snow falls to create a snow base so I do not have to deal with stones and rocks...

The dust boots on the front axel of my 2013 tractor are cracking and likely need replacement. Wondering if this is a DIY project or if I am better taking the machine to a dealer to have them replaced. Thanks.

Has anyone developed an easy method to reinstall the oil drain plug on the BX2755HD snow blower? It is in a very difficult location to remove and reinstall. Wondering if anyone tilts the blower on its front side or one of the ends to make reinstall easier? Nipigonite.

I enjoyed watching your video. I am wondering what method you use to replace the oil drain plug in that impossible location. Looks like you stick your hand in the hole below it and the other one in the small one above, hold your tongue, left eye, right elbow and right knee at the correct angle...

So I hooked up the BX2755HD snow blower this week to give it a try. The install was fairly easy, though I had some difficulty attaching the front shaft between the blower and the quick attachment. Should get easier with experience. Quite impressed with the unit. It runs smoothly and throws...

Hello from the north shore of Lake Superior in Ontario, Canada. I have a second hand 2013 Kubota BX25D with FEL and backhoe. Recently purchased a plow blade (BX2760A) with hydraulic tilt and shoes and a snow blower (BX2755HD) with a hydraulic chute. Machine has been used primarily to maintain...

I used the BX2755hd snow blower for the first time yesterday. Very impressed with the operation, not so impressed with the installation. Found it difficult to install the front shaft between the blower and the shaft on the quick mount frame. It is difficult to pull the locking collar back...

Installed the plow blade on my BX25D recently. Bought the plow shoes too. I clear about 100 yards of gravel driveway and 300 yards of gravel road in the winter as well as our camp lot. Lots of stones sticking up so the shoes make vertical adjustment easy until I get a good snow base. A very...

The dash shows a digital readout of the engine rpm. Thanks for the advice.

I am purchasing a BX2755HD front mount snow blower for my 2013 BX25D tractor. The maximum rpm of my machine is about 3400. Normally I run the tractor at 2500rpm when I am operating the FEL or the backhoe. Wondering what rpm I should be running the snow blower at. Thanks, Paul Nipigon, Ontario