Search results

Has anybody ever had a JD 48 Loader on a 2240 . Does anyone know what Loaders will bolt rite on one.

I have a JD 2240. Just installed rear crank seal from JD. Put a little oil on seal on installation. Has a small leak. Just wondering if this seal should have been installed dry. I used proper install tool for the seal. Don't know why it would be leaking, any help appreciated.

Hey TX Jim, Having a issue with my 2240 rear crank seal. It had a national oil seal in it, rubber lip seal. Installed a JD seal wear ring seal combination and it still leaks, crank journal looked good. Any ideas

Hey Tx Jim, Hearing different ways to check Hyd/ Trans fluid on a JD 2240. What is the proper Way.

I have a JD 2240 , Trying to adjust 3 point hitch. Took out 1/2 drive plug by selective control lever. Adjustment screw inside there won't turn, anybody know why this wouldn't turn. Appreciate any answers.

Just have a question on my 2240 JD. Trying to adjust 3 point hitch. The plug by the selector switch you remove , that is 1/2 drive the adjustment screw inside there won't turn. Anybody have ideas why this wouldn't turn.

Can anybody help me out with a part # on a JD 2240 Rear crank seal installer tool, Would really appreciate.

Can you install a JD 2240 Crank seal without special tool.

My 2240 hand throttle won't hold it's position, Does the spring just need replacing.

I have a 2240, Replaced hydraulic fluid a couple months ago for loud metallic rattle, also filter and cleaned pre - screen. Screen was very dirty and fluid also. Noise is coming back. Could screen be clogged again

I have a JD 2240 rock shaft raises on its own with control lever only half way back anybody have this problem

I have a 1980 2240 with Hydraulic pump noise after starting tractor takes a minute or two for noise to start very loud metallic rattle eveything works noise stops for a second upon engaging pto seems like cavitation can anybody help would appreciate any help thanks