Search results

That was it. Thank you!

Hi all. I have an LS MT125 that I am reassembling after rebuilding the transmission. I bought the tractor partially disassembled with a lot of parts in buckets. For the most part it's going well, but there are these two rubber items that I can't figure out. I've looked all over the tractor and...

Hi all. I have a MT125 that I am reassembling after rebuilding the transmission. I bought the tractor partially disassembled with a lot of parts in buckets. For the most part it's going well, but there are these two rubber items that I can't figure out. I've looked all over the tractor and in...

Arg, when I was looking into buying this tractor I called the local supplyer and asked about the pump, $477 less tax and shipping. I dont know why I didn't aske about the motor. Most of the carnage in the transmission is in the HST. Many of the pistons in the pump are locked up and it looks...

Hi everyone. I have an LS MT125 that I got for cheap. The problem is the transmission is in very bad condition. The previous owner hit something with the hydraulic oil filter (no guard installed) and ran it out of fluid. Then kept trying to make it go until it started making very bad noises...

Hi everyone. I have an LS MT125 that I got for cheap. The problem is the transmission is in very bad condition. The previous owner hit something with the hydraulic oil filter (no guard installed) and ran it out of fluid. Then kept trying to make it go until it started making very bad noises...

Hi, I have a CG2310 that needs front tires. I managed to get the existing tire off the wheel and the wheel is very rusted. Completely gone in some parts of the rim and very thin around the bead. I've been trying to source a new rim, the tire size is 18x8.50-10. Does anyone have a good online...

Hi Everyone, I thought owners of old MF GC2310 tractors, and other models too, might be interested in this project. The steering cylinder and tie rod ends on my GC2310 are shot. I tried getting the cylinder rebuild here in Hawaii but wasn't encouraged by my investigation. Just for grins I looked...

Thanks. I did get a hose to replace that loop fitting. The one that came with my tractor was totally rusted. I was able to get the 3pt to lift, but it doesn't go down with the reverse lever applied. Bad spring or no hydraulic pressure to push it down? I bought an operator's manual, a tractor...

"Is your serial number below or above JNA25201. It can make a difference." Here's what's left of the manufacturer label. I'm not sure how to interpret if it's above or below thw magic number. "I believe the addition of the FEL valve control changers the routing of the hydraulic fluid to the...

A few responses: To WranglerX: "Quick and dirty test of hydraulics/pump would be to put a gauge into one of the quick connects" All the quick disconnects are totally rusted. I don't think any of them will disconnect and some of them are rusted to the point where they just snap off if you...

Thanks again for all the responses. Especially DMW. I have a new video up showing the results of the hydrostatic drive and hydraulics tests. Spoiler: the drive works, as does the steering, but I cant get the 3 pt to raise and lower. It's my feeling that the three point should be a basic part...

Hi Everyone, I'm the new owner of a very rust GC2310 TLB. I bought it for a cheap $500 mostly just so I could use the backhoe arm and hydraulics to build a small tow behind backhoe. But if the tractor can be made to run without spending too much $$ I'd rather just use the platform as it was...