Search results

just to close this out. it turned out that a 3" wire with a plug in style connector was bad. the connection was broken under the rubber coating covering the wire and connector junction. unbelievable that is was that simple. took me three weeks and repeated attempts to tract down the problem...

yes, i tested continuity across pins and they check out as specified. i even swapped relays with the pto relay as they are the same. no change.

last pix pencil shows where there is no voltage. one above it shows where there is voltage ...

agree with your statement. but it was tested under start attempt and the battery stays steady. there is voltage at every location you'd expect before, after turning key to on position and after turning key to start position. except pin 30 on the neutral start relay. so when the key sends...

thank you ... do you know if i should have voltage on pin 3 in the neutral relay with battery connected and voltage on hr18

trying to sort that now. i know i get continuity between pin 1 and 4 when i turn it all the way. but i cannot seem to figure out the continuity between every thing else. i did replace the ignition switch about 4 months ago with a oem switch.

hello everyone. first, i have read and re-read every post of tc29d's various starting issues. however, none have solved my starting issue. second i have checked, rechecked every fuse with a ohm meter to make sure they are good. third, all of my safety switches are working (seat, pto and...