Search results

Well I found out how a stupid mistake almost cost me an engine. I pulled the pump off again and discovered I must have touched the linkage thus misaligned the rack to the governor arm. Reset the shims and pump, aligned the arm and it fired right up. I don’t even need the glow plugs on a fresh...

Should “that” matter?

Yes, I checked it before I aligned it with the governor prior to reinstall. As long as it mated with the yoke prior to assembly, positioning should not matter?

Thank you. After separation from tunnel (between bell housing and 1st tranny, everything came apart as required and replaced gears in reverse order. Installed cover maneuvering the gears with long screwdriver everything dropped into place. Went to start and got a runaway motor.

I have a Iseki TX1500 with KE75 Mitsubishi 2cyl. I have had one heck of a time getting it started after having set for year. New diesel filter, bleeding at filter & inj. Pump. Cracked lines at injectors. As engine turned over, closed off each bleed point when air bubbles stopped. Noticed 1st...

My previous post was in search of a shift gear for my Iseki TX1500F transmission. Thanks to (Tractor Tech), it appears I found a replacement. My only question now is “what is the best way to access the top shift sliders. I was thinking, which got me in this situation to begin with, to separate...

Excellent source of information. You did a great job and a lot of time and effort. Thank you

I am in need of a gear for my Iseki TX1500 transmission. Accordingly, the parts manual identifies this gear as a “gear-sub 15/33T #1871593 I would appreciate any help or suggestions.

I’m baffled! My Iseki TX1500F rear axle is drilled and pinned to accept the hub which can be as you know assembled onto the axle from either side. Having said this it seems if the hub is fitted using the outer most hole on the axle (to gain more width) can the hub handle the stress put on it in...

I have been quite busy and am now at a point when I can get to a few projects. I will try to be as brief as possible and bring you up-to-date with my little Tractor.

By the way, nice build!

Thank you. Is there a loader made for that tractor?

Hello Hello Hello, anyone home😳

Wow! I’m 76, and still respond to posts I find interesting. Guess this one ranks with…if he ain’t from around here his dawg don’t hunt:-)

Thank you sir for the positive thoughts.

The region I best identify with is generally west of the Rockies and East of the Pacific. Oregon

High everyone, need some Devine guidance and intervention. Has anyone installed a Johnson FEL Mod. 27 on a G174? I have it mounted to a Bolens 1476 currently however, I purchased an Bolens (iseki) TX 1500 F. I have approx 5ac of weeds following the removal of 16truck loads timber. I had no idea...

Well, thats a fact, minus i left out it was on a trailor behind my truck. Im the proud owner of a TX1500F. I have repaired and operated a number of Bolen tractors over a course of the last 15yrs. I have found each to be a testament to a past generation when quality was delivered. Now i have a...