assembly

This is not mine... this is from a video here Anyone else seen this kind of corrosion on their fuel sending unit/fuel gauge hardware? Mainly to ask -- is there some manufacturer of these things to avoid or ... Kubota's been pretty consistent with who makes these for them and ... it is what it...

Question out there. Anybody know the best way to dismantle the gearbox assembly on a ft254? I’ve done the tractor split for the clutch a few years and it looks like again for a busted gear tooth just above the transfer case. To me it looks like six bolts just ahead of the transfer case on the...

Hello, rebuilding a Ferguson TO30- 4 cylinder, Crank is installed and main caps are torqued, clearances checked and it rotates no problem (no pistons) Installed the pulley and torqued Crank nut to 130 ftlbs but won't rotate, still no pistons. I back off the Crank nut to finger tight and the...

So I hit a beaver-cut stump with my Woods 720X rotary cutter and sheered off the tailwheel assembly. Unaware that the wheel had broken off, I ran the wheel over and destroyed it. So I'm looking for an inexpensive tailwheel assembly that has a 1-1/2" shank that also has 8-3/4" free play between...

The steering on my MT 160 is getting a bit sloppy. I've read some threads about rebuilding the assembly and am not sure if this may be beyond my capabilities. I've tried to locate some complete assemblies but haven't had much luck. Some threads have mentioned that the same assemblies were...

Trying to locate a good front axle for a yanmar ym240

I have an old Howard rotovator rototiller (Model HN) with a 12 compression spring twin disc pad slip clutch. I had to replace the friction pads recently but found that the metal plate between the friction disc pads is deformed (no longer truly flat - see pictures). As a result one of the new...

I have a Mahindra 2615 and it continuously got harder and harder to lift the 3-pt hitch. I took it apart and greased all linkages. Now this part on driver left pulls out about 1.25 inches. When pushed back in it does not seem to engage. Moving the control lever on the right side has no...

The 907 flail mower I got doesn't have any of the idler pulley bracket, arm or spring. I've bought a new belt and pulley. My question is can I skip the whole spring and arm and just make an adjustable bracket for the pulley to mount to. I would make it with slots to manually adjust the belt...

Pull apart my tie rod assembly today at the point where i am pointing. Put it back together by using front loader to lift wheels , lined up assembly , lowered the tires to the ground, then turned wheel to get it to push back together. It came apart again. Repeated process. Is this...

So, I have a D2000 and the hydraulics suddenly went soft. The pump is good, it will lift some weight but when I turn the tractor off, the 3pt hitch falls unless I have the valve under the seat closed. I have, through t-shooting, determined that's it's probably leaking int he control valve...