brakes

Wet brakes plug

Anyone needing hard to find, expensive disc brake components for Bush Hog Trail Hunter UTV’s… Find exact replacement parts, drawings and parts lists at intellaparts.com. Many of the industrial vehicles listed (like Taylor-Dunn) use the same platform.

I just replaced my trailer (10K) brakes and while I was at it I did the bearings as well since they had some age on them. First let me say I have done bearings on NEW axles before but not replacement on long time USED axles. I followed all the specs as per usual on the bearings but I always...

i got a 2018 5570 2wd the brakes are dragging when you push down the brake peddle you can hear the brakes sqeaking real loud like metal to metal and when i push in the clutch the tractor just stops by itself it sat up for a couple years i tryed driving it in reverse and forward and they just...

I have a new workmaster 105 the brakes sound like metal on metal. Anyone else have the same noise from there new tractor?

I have a Montana 555dtc with a leaking rear brake boot. When the tractor is running it sprays hydraulic fluid out under pressure. My question is should the rear axle have pressure? If not is there a vent that might be clogged or should I be looking for something else? While I have experience...

Hey ya'll I'm back with another DIY farm repair, this time replacing the master cylinders on my 1998 555E backhoe. When we bought it the brakes were okay but a little spongey and after a bit they stopped working. We bought a pair of rebuilt master cylinders online and swapped them out ourselves...

The parking brake on my tractor is pretty much useless. It is a coarse-stepped metal tab on the starboard-side pedal that engages with the footboard (you can see the wear in the photos) and the steps are so far apart for the ratcheting action to provide sufficient pressure to keep the tractor...

I'm having a hard time finding information about what kind of brakes these are. I just opened them up and was expecting the more common type... Just got the trailer - not much information about it (title says it's from 1969) Any help/advice would be much appreciated. And outside view before...

I recently did some work on the brakes of my YM240D. The left side was full of oil. I replaced the seal and no more leaks. I also replaced the shoes and springs with replacements from Hoye. The right side works really well. However, the left side is adjusted as far as it will go and still does...

Actual cluster works. Bulbs all ok. Indicators within same cluster work ok. Wondered if there’s a contact plate closer to the brake pedal or something else between the pedal and cluster that needs attention. Can anyone tell me how to access the wiring or what side panels to remove to get to the...

I have a nice solid tandem trailer, but they built it using axles without flanges. I am handy with welder, wondering if I could weld on a set of flanges. The trailer shop I took it too said the weld on flanges they had would not work, not sure why. I assume they just were not comfortable doing...

Hello everyone, I don't have the Branson anymore, I got myself a Kubota M7060 12 shifts, 2016 with an M21 loader and snow blower, 1340 hours on it, really nice tractor but. The one and only problem with it, and it is quite a serious one is faulty travel brakes. I have to pump the pedals to get...