deutz-allis 5215

Bought 1988 Duetz Allis 5215, 2wd 18hp. Im having problems with the 3pt raising up. When I use up lever it whines and does nothing, then after 15 or so seconds it might raise up some. But it has only lifted the brushog once off the ground. Its just a small 4ft brushog. I have checked the...

I always keep my eye open for weight of all kinds. A few years back I found a bunch of these 10-15lb cast iron stack weights. I made a couple brackets and added 140lbs to the front end of my deutz.

I've come to love my hydraulic top link on my IH Lo-Boy 185, so much so that it's going to be standard equipment on all my machines. I wasn't lucky enough to have the optional aux circuits on my Deutz-Allis 5215, but I plan on adding some. The plan: A.) Interrupt the pump output and run it...

Since 99% of my tractor work is moving trailers or hauling pallets around a functioning 3PT is a MUST for any of my machines. When I picked up my Deutz it didn't have lower arms or lift links. I attempted to source some from Ward's Brothers, but they valued the originals at $500 bucks, which...

I've had my Deutz-Allis 5215 HST for a month or so now and I've put on a few hours. During this time I've noticed what I would consider "excessive, but not extreme" vibration below 800 RPM and Above 1800 RPM. While I wish I had payed more attention in the beginning I do not recall it having...

Due to the lack of available information on the Deutz-Allis 5215 I'm going to start this thread to give a central place to link all my 5215 projects, questions & repairs during the lifetime of my tractor. My plan is to create separate forum posts for each project and and link them below. New...

I picked up a Deutz-Allis 5215 this past weekend with under 300 hours (and the HR meter till works). 3 Cyl Diesel, 2wd, HST Naturally with any "new" tractor purchase there's a bit of a learning curve and a lot of information to absorb. From what I've read parts can be difficult to find, any...

Does anyone know where I can find front tires (5.00-10 three rib ag style) for my 2WD 5215?

I have a Deutz Allis 5215 synchro shift that Ive had since new. I recently moved it from a tractor shed to my shop with a concrete floor and noticed that it drips a little fuel on the floor. I traced this to the injector fuel return line which is just hanging loose at the rear of the engine. I...

I am the proud owner of a 1989 5215 with 1700 hours. I love this thing. It has a 60 inch belly mower on it but I have a few questions. #1. I am doing a full service on my deck which at this point has evolved into me fully stripping it down and repainting it ect, I am going to change the gear...

And could scan me the page on the cylinder head bolt torque sequence and spec? Need to replace the head gasket. Also could use the valve lash spec if there is one. I assume the valve rockers have adjustable lash as I have not torn it down yet as I can atleast move it under its own power for the...

I have a Deutz Allis(hinomoto)5215 that will overheat when mowing, but if just cruising around like we did at the tractor show in the high heat and humidity it did ok, or atleast never popped the red overheat light on. But when I run at PTO rpm mowing after a few min she will boil over and pop...

My wife and I are starting to prepare to move to the country in the next 5 years and a bigger tractor was one of those things. We both agreed that once we do move the income to get a tractor and attachments will not exhist for several years. So...we bought this tractor last night. Runs...

Looking for a loader for a deutz-allis 5215 , any ideas?

I was running low on fuel, added about 1/2 gallon that turned out to be gas (my son had put gas in a diesel can). It ran OK. put it in the shed. Went out the next day and drained the tank and filled with diesel. Primed the pump and filter and tried to prime the injectors, but the pump isn't...

We recently purchased a little Deutz Allis 5215 4WD with a loader for some light farm/garden work. I've noticed that in the steering it turns to the right with no issues and can make a pretty good turn. When turning to the left it doesn't go very far and seems to...not like it (I don't know, not...

Need to pic some brains here, been working on equipment and cars all my life but now I want to tackle an engine swap in my 5215, the 18 hp is tired and underpowered for adding a loader etc and used tractors are stupid expensive. Can figure most of it out but hoping you folks can prepare me for...

Trouble always trying to find parts and accurate info on troubleshooting this remarkable little Tractor. Vermont is hard on it especially Winter. Anyone out there no anyone in Vermont anywhere that KNOWS how to work on this tractor and can help me out.rolland71258

Hi all - i am looking to replace the turf tires on my 5215 with ag tires. the turf tires are on smaller rims than the ag tire require so have been trying to track down the correct size wheels/rims for the tires. the front tires sizes are 6.00-12's and the back tires are 9.5-16. my question...

Hi All, I'm a newbe considering purchase of a Deutz-Allis 5215 HST compact tractor. 4wd, loader bucket, 361 hours, looks good, sounds good, everything works, no leaks. Only obvious problem is a huge dead area in the steering. Turning left you need to spin the steering wheel around more that a...

Anyone know how to mount a second PTO on the 5215 4wd, the manual shows a cover in the front of the rear axel but mine doesn't have it. Maybe only available on 2wd models? Want to mount a bigger hydraulic pump on the second PTO but failing that does anyone know how big a pump I could use if I...

I bought a Deutz Allis 5215 about a month ago. The 3 point lift lift worked fine when I checked it out before buying it. When I got it home and mowed for about 3 hours the lift quit working. The hydraulic fluid was milky. I drained the fluid by jacking up the front end removing the plug and let...

Hi, im new here. ive been on the sidelines checking the website out for a few years just looking for info on posts already up and have been lucky til now. I have a Deutz Allis 5215. Just got it and am tearing into the front end to make the wheels go round and found out the Kingpin seal is a...

Anyone know where I could find a head gasket for my 5215, just had the injectors and pump done and when it wouldn't start I pulled the head and ported the prts and lapped valves but now I need to find a head gasket, better yet would be a gasket and rebuild set, pistons are fine but would be...

anyone know the tire size ratio of the 5215. I have done a calculation of rear circumfrence divided by the front circumfrence to get a ratio of 1.45. I need new turf tires and wanted to go up a few sizes as well as improve snow traction and load capacity, feel free to suggest certain brands...

I want to add a loader bucket to this and run a 20kw pto generator, right now I have a 10 Kw now and I think the engine is about maxed on on power. Anyone have some experience with these small engines. I was thinking about increasing injector pressure or size and custom manifolds to let it...

I've got an older Deutz 5215 Hydrostatic drive. I need #1 PTO gear and possibly another hub gear. I've called a dozen salvage places but nothing out there. Is there anyone that has or knows somebody that might have parts? Thanks!

ANYBODY KNOW WHERE I CAN GET TOP THERMOSTAT HOUSING AND RADIATORS HOSES FOR MY DIESEL 5215? AGCO SAYS OBSOLETE.. WILL PARTS OFF A DIFFERENT BRAND WITH THE SAME ENGINE WORK? THANKS DAVE

I jsut had the hydro transmission repaired...put everything back together and there is not very much power. It goes forward & reverse fine and all the hydraulics seem to work. It has a "whine" when it has to give any extra effort. There just seems to be a major lack of power...

Ive got a Duetz Allis 5215 and need a number for the taller hydro filter on the right side of the rearend. Ive got the number for the small 2 on the left.

Hello, Anyone have a suggestion for finding a frost plug heater to fit a Deutz-Allis 5215 4x4 manual with 1 liter, 3 cylinder Toyosha diesel engine? I think it takes 1 5/8" plug (not completely sure until I get one out--maybe it's metric). I understand this engine was also used in Massey...

I bought a Deutz-Allis 5215 today nice little tractor, anybody know where I get an operators manual for it

I have a 1990 Deutz Allis model 5215 3 cylinder 18hp diesel tractor with front end loader and rear 6' blade. I have had it for 3 years and last year the clutch started to slip after using it for an hour or so and when it was hot. Now this year it is starting to slip a little more so I guess it...

There is a Deutz Allis 5215 for sale on the classified section of TBN, and it happens to be located 10 miles from my house! Any comments on this tractor? I understand that some (all?) D-A diesels are air cooled....other than increased noise, what does this really mean to the user? I currently...