ford 3610

I have a Ford 3610 tractor shooting power steering fluid out of the reservoir and leaking out of the cap, when I fill it up it steers fine just ends up leaking all the fluid out, also it’s frothy fluid see videos attached. I’ve ordered a new filter and ORings just want to make sure the pump...

Thinking on a 3610 with aprox. 3000 hrs. did the 3.1 L, 3 cyl. engines have the porous bore/cavitation issue? is this something to be concerned about? do not know if there was any engine work or if additive was used in coolant. appears to be in excellent condition, newer tires etc. $8000 grand...

I got a 1987 Ford 3610 that has to crank a long time when it's cold but cranks right up the rest of the day after that. I just had the injectors rebuilt. It runs like a champ after starting . It's got clean exhaust no blue smoke. I can give it a little shot of starting fluid and it cranks right...

Dad lived till he was 89 and drove and took care of his tractor up until his last 9 months. Now I have to add hydraulic fluid and I want to be sure this is the right place. Is the bolt in the center of the pic the place to add the fluid? It is behind and slightly to the right of the top link.

Hi all and thank you for stopping in. I'm removing the fuel pump and replacing with a new one but it seems to be stuck to whatever it goes into .. which is where I put oil into the tract or and I can see when I look down into the oil filling hole (sorry I don't know the proper terms for this...

While mowing with my Dad's Ford 3610 the left from tire turned the wrong way. When I lifted the tire off the ground with the FEL the tire fell off. Is this called the spindle axle assembly? How do I go about repairing it?

I recently purchased a ford 3610 and through reading other forums I thought I found the location of the hydraulic fluid check plug near back of the right foot rest. After two weeks of looking at it I talked myself into removing it to check the fluid level. There is a hydraulic line coming out of...

Ford diesel (1982 3610) starts fast, sounds good, slows, sometimes picks back up a little, but always stops after few seconds running. New injectors. Fuel lines to the pump clear. Injector pump worn out or partially plugged? If latter, how do you purge? Other things to check?

We were told about changing the ground wire from the top of the starter to the bell housing, our ground wire goes from the negative side of the battery to the top side of the starter that runs through the bell housing..are you suggesting to run an additional wire at the same point on the starter...

I have a tractor that is basically a hybrid copy of a Ford 3610 and 5610. The hydraulic pump is identical to what is specified in the factory service manual for the Ford/NH 3610, the circuit is as well- I am speaking of the 83996272, 83996336, E1NN600AA, E1NN600AB type pump. Here is my...

First post... A few years ago, I bought a well-used Ford 3610. Looked like it was set up for mowing county roadways or something. But it seemed to run fine. First thing I did was take it to a local dealer and had a Westendorf loader put on it because I really needed a loader. Well, it...

My grandfather has a 1984 3610. He was having problems with it cranking and I checked the starter and battery. Turns out the alternator had quit charging and was not maintaining the battery. I had the alternator rebuilt and the gentleman that did it added an external regulator to the...

My Ford 3610 has a 24" or so handbrake that will stop my tractor when I pull on it, but it doesn't lock in place. The button activates a pawl, but there isn't any hardware in place for the pawl to lock into. Does anyone have a picture of what a complete handbrake assembly is supposed to look...