hydraulic pump

  1. R

    MF 1240 three point wont lift

    I was using the front end loader to move debris with the three point raised on my MF 1240. After completing the task, I parked then lowered the three point and front end bucket. Next day, three point would not raise. Front end loader works fine. Hydraulic fluid checked good. I can see the lift...
  2. D

    Yanmar 2T13 engine or Seeking Hydraulic Pump 'receiving side' - Receiving Side Gear broke

    Seeking 'receiving side' to Hydraulic Pump - Receiving Side Gear broke Ideas ?
  3. D

    Yanmar 1300D 2T75-C Seeking Hydraulic Pump 'receiving side' - Receiving Side Gear broke

    Yanmar 1300D 2T75-C Seeking Hydraulic Pump 'receiving side' - Receiving Side Gear broke
  4. W

    Yanmar hydraulic pump

    Ugh, I am struggling with my Yanmar 1510d . I bought this tractor 2 years ago (auction ? mistake). I just put a new hydraulic pump on it for the 3rd time. FEL and 3 pt hitch have stopped working again. I cleaned the filter and put in new trans/hyd fluid recently. I also installed a pressure...
  5. dalestractor

    Hydraulic pump on farmpro 2425

    Recently I had issues with my hydraulic pump so I pulled it and got a rebuild kit,(some seals and orings ),but when I put them in the seals are thicker than ones that were in it when you tighten the two bolts adasnt from each other you can't turn the shaft with a wrench, any idea's?
  6. I

    Case IH 2290 hydraulic hose connected to the hydraulic pump

    trying to fix my case 2290's hydraulic leak ive identified the leak to the hose that runs from the hydraulic pump to the main controls in the cab, i cant for the life of me figure out how to remove the hose, it spins freely but doesnt unscrew, and its not a push pull release refrence pictures...
  7. Long Valley

    Hydraulic pump whine, massey/agco/iseki

    Hello all, I have an Agco ST41A, which is the same tractor as a Massey 1540, made in Japan by Iseki. The tractor developed hydraulic issues last fall and I'm trying to diagnose before spring. Symptoms were intermittent loss of Hydraulics and definitely whining and chattering noise from the...
  8. C

    New Holland 1925 hydraulic problems

    Hi, I've got a 1997 new holland 1925. It's a hydrostatic, with a 7308 nh loader. I've lost my hydraulics to both the bucket and the three point. Does the hydrostatic transmission use a seperate pump? Tractor still drives fine. I read a few threads on the divererter block and tried turning that...
  9. K

    JD 750 Hydraulic issue

    So my very worn (4400+ hours) 750 was making a heck of a racket when I started her up this morning. Up until now, they hydraulics were smooth but slow and I know I need to rebuild the curl cylinders but that's a project for another time. The motor seemed to be purring quite nicely but I think...
  10. A

    TC29 Hydraulic fluid/pump problems NEW HOLLAND

    Drained hydraulic fluid and chunks of metal and water was in it. Checked fluid because I started having a noisy hydraulic pump till tractor was warm. Now the hydraulics will work sometimes and pump squeals everytime it try’s to lift. Where could the water and pieces of metal be from? Oil is in...
  11. C

    TC40 Hydraulic Pump Seal

    Hello, I have a TC40 New Holland and the hydraulic pump seems to be leaking into the crankcase. I noticed a black streak when I was operating the tractor. Parked it and checked the engine oil and it was over full. Checked the hydro oil and it was nearly gone so this is just my assumption. Now i...
  12. F

    CUT hydraulics 3point

    I have a Ford/Newholland 1215 compact tractor that has a serious whine when raising the 3 point lift. It does raise so I know the pump is working and did notice the fluid reservoir was very low. My question is, could I have damaged the lift or pump running the pump with low fluid and if I drain...
Top