kubota l4300

where to buy manuals for a kubota l4300?

This is a picture of an L4300 Kubota off the net and is typical of many earlier models. Replacing the battery on these models looks, and is difficult. When my battery failed yesterday, I learned an easy way to do it that only involves four bolts. That's all. Before doing anything else, remove...

I have a L4300 GST that will no go in the upper ranges. Lower ranges 2-5 seems to go just. I have changed the fuel filter, air filter and hydraulic filter. What is the T/M fuse? Need suggestions on what to do next. Thanks-Zane

I hadn't used my L4300 DT in a month or two when I went in to start it up recently. When I put in the key and turned it, the dash lights came on for a brief second and then everything went dead as though the battery was dead. But if it was, the lights wouldn't have come on at first, so I'm...

I have an L4300 as well s an MX5100 and use them for seeding and tilling things. Both are rated to lift 2860 lbs at link ends or 2310 lbs at 24 inches back. Usually, I lift 1300 lbs and it's no problem for either tractor, especially the MX5100. I have weights on the front of both tractors. Now...

Noticed a clunk coming from left hand back axle/ hub area when rolling forward or backward in gear or in neutral. Sounds like a wound up heavy spring suddenly releasing. Tractor has been sitting for 2 months.

I have a Kubota L4300 with a tach that fogs up when I use the tractor and does not go away even as the tractor heats up and is used. There obviously is some sort of air leak and I can see that the fogging starts in one area and fans out. The tractor I often used in very dusty environment...

Hope someone can help... have a L4300, drove to job, turned it off. when it was restarted the hazard lights started flashing and couldn't be turned off except by disconnecting the battery. anything i should be looking at here?

I was finishing up rototilling 2 acres of new house lot today and suddenly I noticed the tach on my L4300 was surging. That is, bouncing--and I mean bouncing-- around by maybe 300 to 400 RPM. This sounds weird but I don't think the tractor was running any different. Maybe it was but I had just...

can you install a FEL on a Kubota L4300 and L2800? Both are two wheel drive. Costs?

Reading my owner's manual again, I noticed it says that you are supposed to come to a complete stop before engaging the 4WD. I guess I do that most of the time but there have been occasions when i started to slip at a slow speed and just pulled the 4Wd lever to engage. I thought it was OK to do...

I have an L4300DT with ag tires that i use for landscaping purposes. I do not have a loader on it and don't want one. But I need a little more power and have been thinking of going up a notch to a used MX5000DT-ag tires or even a new MX5100DT-ag tires. Maybe even an L4600DT but I don't think...

Not sure if anyone knows or cares or maybe I'm the last to know but I discovered the inner and out air filters for my JD790 and Kubota L4300 are exactly the same. When I put new JD 790 filters on the shelf next to my Kubota L4300 filters, I was surprised. Deere had it's logo on it but they...

I have a Kubota L4300Dt that I had one (set) remote added at the dealer when I bought it. It's a great addition for moving bigger equipment around or operating a single cylinder. Now I would like to add a second set of remotes and wonder if anyone has any idea what this cost might be. The...

When at idle, the FEL will no longer lift the arms even when bucket is empty (bucket curl "seems" OK...but may not be). When I go to remove the FEL by lifting the front wheels off the floor, there is barely enough power to do it with either lift or bucket curl, even when revving the engine...

I have a four year old gear drive L4300 4wd with gear drive, draft control and one two-spool hydraulic valve. Has 200 hours, ag tires, always in nice barn and never even been wet. Looks mint. I only use to do light farm/yard work. I am getting older and really like the HST transmission so am...

I have a question after having the PTO upgraded to remove the ratcheting noise. Without the ratcheting over ride feature is there an issue with engaging the PTO if you have something like a rotary cutter that has not stopped moving when you are ready to go again? I have been throttling down...

I have an L4300 gear drive Kubota with ag tires and set up for crop things with the rear tires set on a 60 inch center. I must have adjustable ag tires/wheels to set up this way. I like this tractor for a lot because it is four cylinder, has lots of power and is FWD. I also like it's compact...

I have a Kubota L4300and want to get a hydraulic toplink (top-n-tilt) for it. The question is, do I get one with a check-valve built in or does the tractor itself have a "check valve" built into it? I already have outlets on the back. It's much cheaper to get one without the check valve. I...

I posted a thread a while back since I wanted to mow at dusk with my B7800 and the lights were not sufficient. I plan to put them on the weight bracket of the B7800. I have tried them on other tractor ROPS before but the shadow makes it hard to see. Here is a photo of my L4300 with the lights...

Howdy I am going to put on a 10k lb hydraulic winch on the tractor for the purpose of pulling a wagon up the side of a very steep hill. Pry 200 feet of pulling at a time. The tractor came with the block type hydraulic unit, and I am afraid that all of the ports are used up with the front end...

L4300 with 84\" finishing Mower I am looking at buying a L4300 with HST. I believe it has a PTO hp of 29 or 27. Most 84" brands call for a min. of 30 HP at PTO. How crucial is this. I will be mowing almost flat ground all the time about 5 acres. And will be keeping it cut low once every 7-10...

My '04 L4300 has independent hydraulic PTO. I've been using it to run a Woods Brush Bull 720. The combination seems to work rather well in the brush I have, but the BB 720 is clearly near the upper end of what the tractor can handle. When I disengage the PTO at operating RPM, the Brush Bull...

Does the L4300 or L4400 have basically the same frame or set up as the L3400? The dealership near me doesn't have the L4400 or L4300, but it sounds like one tough, powerful tractor. I hear the L4400 took the place of the L4300, but the running gear didn't change only the "body style", is that...

We are looking at a L3400 standard shift with a FEL as an auxillary tractor for our farm. We need a tractor to save this old man's back when cleaning manure out of the cattle barn, taking hay out to the cattle, moving equipment, doing fire woood, and light plowing, etc. Has anyone else used...

Hi, my dad bought a new L4300 earlier this year, and he's going to use it to plow with. I thought I'd get him a cab for Christmas. Any recommendations for companies offering aftermarket cabs? Used product sites? Anything else I need to know? I'm most interested in a lower end, softsided...

I have been looking at a slightly used (50 hour) L4300 with a LB 552 FEL. The asking price is $17,500. I thought it sounded reasonable until I called a couple of kubota dealers in Middle Tennessee. They gave me quotes on NEW L4300 with a LB 552 loader of $18,900 and $18,700. However they...

Please let me preface this by stating that I don't want this to turn into an HST/GST debate. I recently bought a very nice used Kubota B2710, and while I really like the HST for a lot of things, it's just not quite enough tractor for me. The local dealer tells me he wouldn't use it to pull a...

Does anyone know the approx. price for a L4300? I was talking to a dealer last night and I think he quoted the wrong tractor for me. I asked for one the would pull a 6' bush hog. He suggested a L3400, but I think that is one size to small. It was quoted at $15,500 w/FEL. I was also...

All with a front end loader and shredder. I am a South Texas girl...w/18 acres (13 coastal/5 residence), a small river on the edge of property (not so, if it floods) with some holes/leveling needed throughout property. I will ocassionally move a round bale or two around to different locations...

New L2800, L3400, L4300 info pages http://www.carverequipment.com/standard_l_series_menu.htm Thanks, Steve

Hello All, Just recieved a new (1/10th of an hour) L4300 with 6' rotary mower and 9" PHD. I was reading in the owners manual about the first 50 hour "break in" period. It said that the tractor should not be ran at full speed. I'm assuming that means the max engine RPM's. The max RPM's for...

Hello All, We are set to buy a new Kubota but are having trouble deciding between these two models. We have fifty acres in the mountians of central VA. We have started an orchard and will be doing some fencing (read using a post hole digger) some time in the future. I bush-hog about 20 acres...

I am a tractor novice. Will be improving 55 acres of hilly, sloped land. Jobs planned: grading two gravel roads, brush clearing, tree removal, minor logging, general maintenance. Have narrowed search to above Kubotas. Both will be equipped with max load capacity FEL with HD bucket. Box...

<font color="#666666"> </font> Hi guys! We're trying to decide between a JD990 and a Kubota L4300 and don't really know much about either. Both are 2WD (don't need a 4)..the 990 has 40hp and the 4300 has 45hp. Both are comparably priced (JD 1k more). We are hearing good and bad about both...

I went yesterday to the local dealer to have a look at the possibilities of financing my future tractor.My price range was set around the L4300 which gives lots of tractor for the money. Here in Canada the financing for the L4300 that I have in mind is 8.25% and to my surprise the financing for...

Has anyone read anything about the new L4300 DT? Apparently a larger version of the L2600/L3000. Anyone know anything about pricing? I was just about ready to trade my 2wd Ford for a new L3000 but now I might have to wait a little while.