long 610

I have a Long 610. It’s leaking engine oil between engine and bell housing on the left side. A lot! Up high. There was a past post about this with no results written. Any help would be appreciated. I assume it’s an oil gallery plug. I plan on splitting the tractor soon. Thanks

My dad has a Long 610 that sat up for about 6 months and now when we start it, oil spits/leaks out of the breather tube. It is hard to start and runs roughly. You can see the black spot on the grass below the breather tube, that’s about 60 seconds after start (and yes I know it’s a rough looking...

Hello , I have a long 610 that has been sitting a few months. I went to start it the lost few days, it will fire on starting fluid but dies when the starting burns off. I知 not even getting smoke out of the tail pipe when cranking. I bleed the injector pump and I even cracked the lines on the...

A gentleman in my area is selling a Long 610. It looks to be in pretty good shape from the pics on the internet. Has 1095 hours on it. I don't know a thing about these tractors but it looks good and would be a nice jump (almost double) in horsepower from my current tractor. Can someone tell me a...

I just bought a 1982 Long 610, the previous owner only started it by using the block heater, and sometimes ether. It has the thermostart plug on the intake manifold but I can't figure out how to turn it on. The tractor only has 3 switches: start button, headlights and the key. The key has 5...

I have a 1984 Long 610 4x4 and its pressure plate center spline plate sheared its rivets off. Where can I have it rebuilt. I found a rebuilt for $589 + $80 shipping plus $250 core. There has to be a better way. Thanks everyone!

I have acquired a Long 610 and I think there is a problem. I cannot engage the PTO without turning the tractor off. I should be able to engage/disengage the PTO while operating my rotary mower. Tried with clutch both in and out. Is there a trick?

Hello I recently purchased a long 610 tractor and I am looking for any information on it I can get. Please email me at moondog7879@yahoo.com if anyone can help me out. Thanks

I've got what I think is a Long 610 (data plate missing) that had the engine replaced before I got it. Now it's spun a bearing and it turns out that the main bearing journals and rod journals are larger than what the 610 engine calls for and I can not find anyone that has any idea of what this...