mahindra 3016

Any help with detail instructions how to do is appreciated. Under tracor I can hear clicking into gear same as fwd. Fwd works fine. So I feel must be inside trans. So must split tractor Instructions would be much appreciated Hal Woodville Tx

Working on a friends tractor. It sat for a while and got water in the bell housing The clutch stuck to the flywheel , I assume it got hot, the throw out bearing is stuck and the fingers on the pressure plate were destroyed. Every single finger broke and scattered around the bell housing...

Good afternoon! Long time viewer of threads, first time posting. I am trying to figure out how to determine which "part" this is that is actually leaking so I can order from the Mahindra catalog. Its a seal of some sort that comes from the transmission/ hydraulic sump area where it transfers...

So I recently picked up a 2012 mahindra 3016 hst, whoever owned it previously seemed to have had an issue with one of the starting interlocks, because they just installed a push button to the starter solenoid that's hot all the time to start the tractor. The power to ignition circuit still...

Hi guys I'm in need of some help with my tractor. I'm having to pull my fuel line off at the fuel bowl, push air towards the tank and once the air comes out the fuel bowl I'm good to go. I reinstall the line and the tractor will run perfect for about ten minutes, under load or not. So far I have...

We purchased new in 2011 a Mahindra 3016 Shuttle We have had LOTS of issues with there being debris in the Fuel Tank like metal and plastic little pieces. We have gone thru LOTS of fuel filters and also had a repair guy try to remove as much debris as he could with tweezers. Now even after...