mahindra 7520

Hey folks. I have a 2007 Mahindra 7520 which I've owned since new. Recently it started intermittently beeping while in use, typically about 15-20 minutes after starting it. I've done all the maintenance on it recently, it has new trans oil/filter, engine oil/filter, fuel filters, and recently...

hydraulic fluid in engine oil i have a 2008 mahindra 7520 4wd tractor with front loader. i was doing some mowing and grubbing some small mesquite trees when i noticed my hydraulics getting sluggish and slow to operate so i went and parked my tractor. when i stopped the engine i noticed oil...

Tell me a little about the Mahindra 7520/Loader. Will it have a power shuttle or do you have to use the clutch? 12 speeds, so is it a 4 speed trans and 3 speed transfer case? Durable? Does 1200 hours mean worn out or just broken in? Is there any pollution control on the Mahindra 7520? How...

Hi. I have a 7520 4WD that's 10 years old and has about 1000 hours. The right front is making a squeaking noise when rolling. It's worse when it's cold, and will sometimes silence after using for 15 minutes or so. But it's getting worse over the last several months. I'm 99% sure it is the...

Hello. Needing some help with adding hydraulic fluid to a Mahindra 7520 . I just have bought this tractor, got it at a fairly good deal and trying to make sure all fluids and filters are ready to go . I have already changed engine oil ,filter,air filters,power steering filter and both fuel...

Today while bush-hogging, the light on my dash that is the battery symbol came on. I turned tractor off several times and it started right back up but the light came on again every time. At dark, I turned on my lights and finished the bush-hogging in the dark for about 1.5 hours. When I got...

Hello, On my 7520 the fuel filler location is behind the seat. On some I see for sale on "Fastline" or "Tractor House" the fuel filler location is just forward of the left step. Also it 'looks' like some of them don't have the three-step PTO engagement. (disengage PTO clutch/engage PTO...

Dealer replace engine under warranty. Since replacement the rear 3pt lift arms has not worked. Oil and filters has been changed. All remotes been checked at 2600 psi. Lift arm levers are not stuck. Dealers said there is no oil flow charts so I can see if I can chase the problem that way...

Ok my 2007 Mahindra 7520 4WD with almost 2000 hrs has bad front cv joints...specifically the cups/needle bearings are shot and that makes loud bangs when 4WD is engaged Anyhow my dealer tells me they are $560 per side! The issue is that Mahindra sells the whole assembly (forks, crosses...

The oils that are specified in the owner's manual are not available locally for me. I had picked up a pail of chevron 1000 thf that I used, but I need more oil now. I have a NAPA dealer and advance auto close by. Is there something more easily available that I could get for this transmission...

Folks, I need some help. I have a 2006 Mahindra 7520 FWA and loader. Currently it has 4xx hours on it. I really like the tractor as it is heavy and has a phenomenal FEL and 3-point lift capacity. Also, it fits me very well. The controls are well placed. I call it my mule. I even pulled a...

Hello all, New to me as of yesterday - a Mahindra 7520 Details: 2006 Mahindra 7520 164 hours FWA 275 FEL ( Mahindra Q/A ) would rather have SS but not much choice when you buy used. Paint isn't even worn off the cutting edge of the bucket. 4 foot clamp on forks. Need to be careful with...

I have a 60 acre mini ranch and raise cattle and goats. I move and feed round bales, do field work (discing, mowing, manure spreading), barn cleaning, occasional dirt work, drive grading, etc. I took a day off and went to every dealer I could find in a 60 mile radius yesterday. Out of...

It has been nothing but one problem right after another since I bought it new in late August 2006. I now have 95 hours on it and have had more problems. Tonight I loaded it back up on my trailer and hauled it 36 miles to my dealer and left it in his parking lot. Back in the winter it started...

I am having a tough time deciding between a Mahindra 7520 4WD and a comparable Kubota M7040 4WD or M8540 4WD. My local Mahindra dealer (60 miles away) will sell me the 7520 4WD for $24,000 (special state fair price). No cab or FEL. My local Kubota dealer (1 mile away) will sell me the M7040...

I am having a tough time deciding between a Mahindra 7520 4WD and a comparable Kubota M7040 4WD or M8540 4WD. My local Mahindra dealer (60 miles away) will sell me the 7520 4WD for $24,000 (special state fair price). My local Kubota dealer (1 mile away) will sell me the M7040 with hdyraulic...

I am considering purchasing a new Mahindra 7520 but I am not convinced that I need 4WD. I currently have a Ford 9600 with an FEL and a Case 1490. Both are 2WD. I have found that FELs can cause a lot of issues on a tractor so I plan on keeping my Ford just for the FEL. I have also found that...

I took delivery of my new Mahindra 7520 4 WD today. I got it with the ML 275 loader, skid steer quick attach adapter, skid steer 84" bucket, skid steer pallet forks, skid steer bale spear, Mahindra grille guard and the aluminum diamond plate canopy. My dealer delivered it this morning around...

MAHINDRA 7520 \"HEAT HOUSER\" DOES ANYONE MAKE A "HEAT HOUSER" TO FIT THE 7520 MFWD W/LOADER? MY DEALER CAN'T FIND ONE. THEY TRIED TO FIT ONE FOR A 6500 AND IT WOULDN'T WORK. HELP, ITS GETTING COLD.

SUNBELT EXPO Pictures will be posted on Tuesday. Many dealers have them on order but have yet to see them delivered yet.

I just went to my local dealer to see the 7520. WOW!! What a nice tractor. They sure did many improvements over the 6500. I am just curious if there are any folks out there who have tried one or bought one and how they like it?? Also has anyone priced one with a loader and how much was it...

Hello all. I am new to TBN. I currently own a 2wd JD301A which is the yellow heavy industrial version of a 2030 (for sale) and have been looking hard at the Mahindra's 00 series for a 4wd upgrade. I've finally had too many close ones on the hills of middle tennessee. I ran across a press...