'06 Montana 4340 having gas gauge issues - KEY ON Shows Constant Full
Took out the Sender/float and measured a full swing from UP [full] position 10 ohms to 127 ohms full down [empty]
Key OFF
Tank 1/3rd full 5 of 16 gallons [spec]
Gauge sits at E [expected]
Sender disconnected - 2 wire reads...
For those that have Montana tractors an issue can be that they slowly start to lose power and eventually get to where they will only idle. After waiting several days the tractor might start up and idle up fine but within 5 - 10 minutes the RPMs will slowing start dropping off. The first...
Just got a '06 Montana 4340 to fix up at a great price, and looking for a reference or solution.
The seat assembly has a new chair and slide, but find the entire seat's scissor suspension seems to "flop" all over the place.
I have taken the entire assemble off the pan, as well as the seat/slide...
I was shredding with my Montana 4340 and had my loader and bucket raised. As I was shredding the bucket suddenly fell all the way down like the cylinders were pressurized. My first thought was that something broke on the joystick but I found no issues there. I checked the quick couplers and they...
I have a Montana 4340 that doesn't want to move unless you are in a very low gear or creeper mode. In high gear, you can get it to move if you throttle up real high. Even though it still moves really slow and even if you hit a small bump it comes to a stop. If I understand correctly, this would...
Montana 4340 Repair Manual / Fuel Problem
Hi.
New to the forum. Was hoping someone had a PDF of the Service manual for a 4340.
Tractor won't start, not getting fuel to the injectors.
I was able to use the prime pump on the filter housing to gel fuel to come out the air bleeder on the injector...
I have a steering cylinder that is leaking on my Montana 4340. I can't figure out how to disassemble it so I can replace the seals. Everything I can find online about rebuilding cylinders they have a head that screws off. This cylinder appears the be one solid piece that doesn't come apart...
Hey folks, I am brand new to this forum and figured this would be the right place for advise.
I am considering buying a Montana 4340c in in good working order no problems with a cab43 hp ,Mitsubishi diesel, 323 hrs. For $17,000 I thought I'd ask around on here to see if anyone still owns one or...
For anyone interesed, I have a 2005 LS Montana 4340 for sale. Under 300 hours, 43 HP, 4WD, dual rear remotes, power steering, liquid cooled 4 cylinder 2.3 L SQ4S Mitsubihi engine, 16/16 syncronized shuttle shift with crepper gear, industrial tires with 90% tread, wet brakes, and all the bells...
Hi,
I have a near new 2006 LS Montana 4340 tractor for sale. Has 285 hours, 43 HP, 4WD, dual rear hydraulics, power steering, liquid cooled 4 cylinder 2.3 L S4QS Mitsubishi engine, 16/16 syncronized shuttle shift transmission, R-4 Industrial tires, wet brakes, 90 % rubber, and all the bells and...
For anyone interested, I have a 2005 Montana 4340 by LS for sale, 43 HP, under 300 Hrs, loaded with all the bells and whistles, near new in looks and function, 90 % rubber, Power everything, rear hydraulics, 4WD, Mitsubishi engine, a real workhorse, letting go for a steal at $10,300. Too much...
I have a montana 4340 and just purchased a bush hog for it. i hooked it up, turned it on and the pto will not turn off. I have pulled the fuse which had no effect. i removed the valve from the block on side of trans that engages the pto, put the solenoid on it and turned the pto switch on and...