noise

  1. E

    GT2550 Kohler engine, valve train noise

    I recently purchased a 2008 GT2550, and I have no experience with the Kohler CH670-0011. The engine ran a little rough, but evened out when it warmed up. Recent oil and filter change, along with hydraulic fluid. About 700 hours usage. Fresh gas and some fuel system cleaner, and it seemed to be...
  2. M

    Clicking noise from front right wheel in 4WD GC1710

    I have a 2014 MF 1710 TLB. 450 hours. Recently I noticed a clicking or tapping sound which seems to be coming from the front right wheel hub when the 4wd is engaged. I am thinking some sort of bearing issue maybe? Also looking for source for a service manual. I checked the website and there...
  3. T

    hydraulic hoses and ticking noise

    I'm a newbie. Just bought a 2005 model 790 JD tractor. Looking at replacing all the flex hydraulic hoses. Some look too long. Would like to get specs on lengths of hoses. Also, when in low low gear I can hear a "ticking" noise at the rear end. I'm not familiar with names of parts so...
  4. D

    Case IH 245 Tachometer bouncing around and making whining noise?

    See video/sound and pics here- Tractor Tach I'm guessing I need a new cable. Any tips for replacement? Should I remove black instrument panel to access the back of the tach? Should I disconnect at engine while operating until I get it fixed? Do tachometer cables need any periodic lube...
  5. S

    Noise?

    Have Challenger 750 MX does anyone have any noise dampening ideas?
  6. Kracken

    99 Cub Cadet 7300 grinding noise

    I have a 1999 cub cadet 7300 with 800 hours, I was moving some equipment around today with it, and I noticed the grinding noise while backing up . I’ve pretty much eliminated the front end from the equation and I believe the Driveshaft. I used the loader to pick it up off the ground and turn...
  7. Rustyferrious

    Front end gear noise?

    Hi All, my 2015 BX25D needed the seals replaced on the vertical stub shaft where the final drive connects. I also figured I'd replace the bearings and final drive seals since I would have it all apart and the BX has a little over 800 hours on it. There's a pretty good Utube video that shows how...
  8. Rosch42

    Making loud clacking noise when trying to start

    I have a 2001 Long Agribusiness 390 HST (version prior to the Farmtrac) that's making a loud clacking noise when trying to start. I don't mean a clicking noise like if the battery was dead or solenoid issue. This is louder and sounds mechanical. At first if it made this noise the engine would...
  9. D

    Strange noise

    Hi, I have a new noise issue with my summit tractor. It's a sound I have not heard until recently. When just releasing the reverse pedal the tractor makes a deep clacking sound. It makes the sound in 2wd or 4wd. Does not make this sound in forward speed when I release the pedal. Not sure if its...
  10. M

    Mahindra 3616 HST making horn like noise?

    I have a Mahindra 3616 HST tractor and I was using it to rip some dirt up with box blade and I put it in 4wd for this for the most traction and all the sudden a horn like beep noise came on it was solid only stopped once I turned the tractor off and all the warning lights on my tractor have been...
  11. B

    Noise after turning off engine

    My friend has a new DK6020. When he turns it off there is a noise that lasts a few seconds and sounds like the air blending door moving on a car's heating system. I used a stethoscope to try to figure out where it's coming from, I think it's the silver aluminum thing in the upper left part of...
  12. F

    Case Farmall 31 Clutch noise

    Have a Case IH Farmall 31 that has a whinning noise when you release the clutch pedal. Once the pedal is depressed the noose goes away. I just split the tractor and replaced the release bearing.
  13. C

    Mahindra 3510 engine popping noise

    I have a Mahindra 3510 3cyl, 34hp. After setting for a month we started it and it smokes out the exhaust and makes a loud popping noise near the back of the engine on the right side. It does quit smoking for a while the starts smoking again. Drained fuel and add 5 gal new with a fuel additive...
  14. B

    Engine noise on new CX2510

    I took delivery on a new CX2510 about a week ago. Other than screws rattling loose on the brush guard, it seems to run great, although I’m uncertain if a couple things are normal or not. The diesel noise is loud when the pistons fire; I expected that. But there is a marbles, bell ringing kind...
  15. K

    74 JD 300B ratcheting noise when applying breaks

    Hello I purchased a 1974 JD 300B backhoe November 23, ran fine and brakes/hydraulics operated as one would expect. Engine and hyd oil/filters were in need of replacement which I did in the spring of 24. I know the brakes worked fine when I parked it the fall before as they held the tractor...
  16. B

    T2290 Noise

    I have a T2290 that makes noise when you disengage the brake. If you look underneath with the motor running and push down the brake pedal it stops. You can see the belt moving when brake is released. Belt stops when you push down on the brake and the noise goes away. I'm wondering if this is a...
  17. C

    ct445 loud noise under dash area

    have a noise that just started and getting worse. sounds like your swinging an 1/4 inch bolt around hitting a tin can. as rpm increases so does the noise. having trouble locating the source due to engine noise. Is the tach electronic or via cable. its the only thing thats rotating. any ideas?
  18. J

    M6800 got hot, small pop noise, then lost some coolant and steamed.

    Cant find a bad hose, could the radiator have pressurized and popped, is the cap a pressure relief type?
  19. macdoesit

    Brake noise

    2007 New Holland TC30 when I push the brake pedal it makes a rough noise for about 1 second and goes away. How do you know when the brakes need changing, where are they and how hard is it to change. Thank you.
  20. 1990F-150

    Hydraulic Noise at Startup

    My MT240 has a noticeable hydraulic squeal at startup. It only happens for a few seconds and when the tractor has been sitting for a few days. Is this a common issue? Should I be concerned or should I not worry about it. I have been on a friend's Kubota tractor that seemed to make the same noise...
  21. C

    Ls4140HC annoying noise from dashboard

    My ls4140 had a rattling (buzzing sound) at different engine revs' that was very annoying. The fix was very easy but not very obvious at first. The sound was like lead shot vibrating on a glass plate. My first guess was the throttle linkage inside the dash and this was only partially the fault...
  22. D

    B1750 starts but won't move, just makes grinding noise when clutch is let engaged.

    I bought an older b1750 HST 4x4 a few months ago. I had been using it with no problems and backed it up to my tiller one evening, thinking that I would hook up to the tiller in a day or two. Although I had no problems when I parked it, I went to get it and hook up to my tiller but after I...
  23. Vokey65

    T474 loud wind noise

    Got a brand new 474 and during throttle increase there is a significant wind noise coming from the hood. I can only assume it's from the fan or exhaust going through the dpf on top of the engine. Just curious if everyone else experiencing the same noise. I'm used to my dad's old JD 4210 and it...
  24. Futterman

    Kioti K9 2400 CVT belt squeal (similar to Mechron)

    Hello, new member here. I've got a Kioti K9 2400 bought new in Spring of 2022 that has 35 hours on it. When I start it up cold and back it out of the barn, the CVT belt often squeals loudly. Once underway, it stops making noise after a moment. If I stop and shut down for a minute, upon starting...
  25. M

    GC1705 Mid Mount Mower Noise

    I have a 2018/2019 GC1705 with the 54" mid mount mower deck. For a tractor, it does a nice job of mowing. Nothing out of line, even cuts. My issue is a strange buzzing/screaching noise that happens occasionally. It is loud enough to catch attention of others outside my yard. It has occurred...
  26. Z

    1835M Power Steering Concerns

    I have an 1835MHC that I bought this past spring. It is used 80% of the time for mowing. I generally leave the loader off for easier trimming next to objects and only attach it when I need it. I have noticed that with the loader installed that my power steering loses quite a bit of power...
Top