Does anyone have a diagram showing the location of the hydraulic temperature sensor?
I need to swap mine out unfortunately and need some guidance where I can find it
Thank you
I just bought this t650 at an auction. Had a water in fuel code set. Should be an easy fix right?
I tried opening the drain on the filter. NO water seen and still had the water in fuel sensor code set. Still had the error code so I bought a new filter and put it on. Code never cleared...
My MF1754 has developed some kind of sensor and/or control unit issue. Most prominent is a false overheating event because a speaker somewhere shrieks periodically due to it. A stone cold engine does not even need to be started. The issue presents when turning the ignition to electrical. The...
I have a 2020 1734E that has been great from the git-go except for the fuel gauge quit working within 6 months.....the dealer wants $250 to take it to the shop. I was told it's a 2 hour job. I'm pretty handy and would like some info about how to proceed with this repair.
Thanks!
First post but I've had my 110 for 6 years... love it and it runs like a champ (deere). Recently I have been getting a fault code after the machine has warmed up and run a bit. I checked the connector next to the rear transfer case and it's not disconnected. It's a bit tight to get into that...
I was tending to my birds this morning, filling up a duckling *ahem* kiddie pool for the young ducks & geese, and I noted in passing that while I had a decent (but not impressive) amount of water flowing, there wasn't much pressure. Oh well.
Luckily my next morning chore spot was letting out my...
The Kubota technician read the ECM and said I need to replace the Exhaust Gas Temp Sensor 0 (zero), Black. The Kubota parts site says it is Sensor (Thermo,0) Black; 1J500-18500. I think I can order one online and do it myself. Can I expect the check engine light to then go off, tractor be able...
Hi, I’m having problems finding a stubby temperature sender for the V5105 four-cylinder motor. It goes on a Miller, welder. Engine serial number 200573.
I asked this question on the onlycubcadets forum but I thought I'd check here too.
There is fuel leaking around the circled part which I think is the fuel level sensor. How would I fix this. I can't seem to get it to pry out to check or replace the gasket or grommet. I don't want to pry...
Need a little assistance finding Temperature Sensor and Oil Sending unit and getting them wired back up.
Several years ago parked my Kubota M4800 in a 3 wall dirt floor garage and rats chewed on the heart of the wiring harness in the dash leaving lots of bare copper exposed. At that time the...