shredder

I have deep sand on roughly 125 acres of pasture. In the dry summer months, the factory tires on batwing will sink and bury up in the sand, then its a major PITA to get it out. Has anyone tried/converted to flotation tires...do they even make them for a batwing? I found some foam filled via a...

Looking for a small chipper/shredder for my wife to pull around behind the four wheeler to clean up fruit tree cuttings, grape vines, small branches, tons of maple leaves, etc. We have a Woodland Mills WC68 for the heavy duty that isn't firewood, but looking for something around $1500+/- to take...

I have a 4 foot shredder that has a leaky gearbox seal. I know the gearbox is a Warner, but I can’t tell the model number. The shredder doesn’t have any markings on it to help me either. Can anyone identify the shredder brand? I’ve attached pictures of the shredder and the gearbox itself.

Looking at a TYM T574 HST and wondering if it would run a 6' shredder on the PTO and a Lane Shark off the front (probably through the rear hydros for flow reasons) at the same time. Or would this be too much of a draw on the hydraulic system? Im in the woods and it would be awful handy for...

Hello, can anyone tell me if this company has operator's manuals AND if not, what weight oil do we use in the gear box? Thanks!

The owners manual for my 6’ Titan says to grease the zerks every 8 hrs. Why aren’t they lubricated for life like they are on trucks?

know this has been discussed. my story: 2019 M1735 - drained and bled main fuel filter - cleaned outter air filter/ inner element ok - added tractor oil (was pretty low) - engine only bogs under bb7200X shredder. grass is not that high. -disengage pto and all is good. when it begins to bog i...

I have a Landpride 2072 shredder and the rubber front guards are ripping off. I've looked at Chains and they are close to $300. Rubber replacements are $25. Has anyone used anything different that is more durable than the 1/4 inch or 3/8 inch whatever it is or should I just go ahead and rebuy...

MTD 5hp chipper shredder that I want to replace the motor with a new (but about 6 years old in box) Harbor Freight 6.5 hp motor. Best I can measure, I get 5/8” diameter shaft on the HF, but the original motor has a 7/8” diameter at the end of the tapered shaft. I’m seeing lots of adapters out...

My current 6 foot RC is nowhere near enough for the tractor I'm pulling it with. Money is a little tight, but I found a 8 foot RC for CHEAP.. catch is that the internals to the T-Box (center gearbox) are completely gone - center gear box housing is there to compare a new one to, but nothing...