temperature

Hi guys, a few issues I noticed while using my recently purchased 3510 for the first time doing a decent amount of loader work today… 1. I noticed the temp gauge was higher than I thought it should be. Granted temps were 90°.. higher humidity.. real feel 100°.. attached is the photo of the...

Can anyone suggest Branson 2810 temperature sensor crossover? I'd love to be able to find an alternative to finding/waiting for shipping/high cost of getting one from a Branson dealer? Anyone know of a "generic" one that might work? Thank you in advance.

Any ideas on why the fuel and temp guage arnt working

Hi all, so I mainly operate my tractor for a small composting business I run. I recently had a problem with a weird sound coming from the tractor which would disappear when I would operate my front loader. Turned out that my hydraulic filter was really dirty. So after a clean, the sound...

Does anybody out there know the factory voltage to the temperature sending unit from the guage. This is for a bx2350d. Any help appreciated.

570 hrs, runs fine, just that temp guage needle never moves more than about 1/8" up from cold even when run hard. Needle does fall back when ignition is turned off, so that part works. Where should the temp be? Thinking about changing thermostat.

Hi, I’m having problems finding a stubby temperature sender for the V5105 four-cylinder motor. It goes on a Miller, welder. Engine serial number 200573.

Can you put a temp gauge on a Farmall Super A? If so, how?

Need a little assistance finding Temperature Sensor and Oil Sending unit and getting them wired back up. Several years ago parked my Kubota M4800 in a 3 wall dirt floor garage and rats chewed on the heart of the wiring harness in the dash leaving lots of bare copper exposed. At that time the...