tie rod

Can any one tell me where I can get tie rod for my 2004 century 2535 or part number

2001 farmtrac 320dtc Korean built also badged LG So I noticed some play in my tie rod end on the right side while plowing snow. Thought maybe tie rod end was worn but it wasn't. Hoping nut was loose but it wasn't so it's oh crap. Looks like the hole in the steering knuckle is worn. Thoughts...

I have searched high and low and cannot find tie rod ends for my tractor. It is an Iseki TU1700F (White 21 Field Boss) The part numbers are TP11128 for the Right Handed thread and TP11125 for the Left Handed thread. I thought "How hard could it be to find tie rod ends"? Little did I know. Any...

I don't know the name if it, but the part that includes the wheel spindle is bent out of shape and the tie rod ends are shot. I've done a back-yard mechanic repair with a hammer and anvil, and it's pretty good, but I can't find replacement parts to make it just right. Any suggestions? Model...

My 5065e is 11 years old and these have cracked, likely dry rotted. I would like to replace them without removing the tie rod end. It looks like you can loosen the jam nut, then turn the flats on the opposite end, unthreading the shaft from the tie rod. When you do this , the joint must...

Broke a tie rod last week, ordered a replacement, got in the shop to do it and a bit flummoxed. My rig has the flat part on the hydraulic steering shaft on the drivers side which seems to be different than others, but when we got a hold of that and turned the broken side, the steering shaft...

I put a nice 90-degree bend in my driver's side rear tie rod yesterday. I had an old "emergency" tie rod that is/was a scabby-welded piece of junk (long story), so I decided to replace the bent tie rod with that until a new part shows-up later this week. Anyway, removing the tie rod linkage at...

How do I remove the right side? Try tie rod end on a Kioti tractor.

I was doing my seasonal maintenance on a 3 year old 3620H and found both tie rod ends are loose at the ball coupling. Tractor has 250 hours and I have been relatively careful about not overloading the front end, turning to the stops and not turning while the tractor is stationary but they are...

Pull apart my tie rod assembly today at the point where i am pointing. Put it back together by using front loader to lift wheels , lined up assembly , lowered the tires to the ground, then turned wheel to get it to push back together. It came apart again. Repeated process. Is this...

Hey guys, I bent my steering drag link real bad on my old Yanmar 1510. Home Tractor Parts doesn't have one in stocker in their boneyard, and they can't tell me to use one from a different model (for legal purposes I'm sure, and I get that). But the rep also told me to come over here and ask...

Hey guys, I bent my steering drag link real bad on my old Yanmar 1510. Home Tractor Parts doesn't have one in stocker in their boneyard, and they can't tell me to use one from a different model (for legal purposes I'm sure, and I get that). But the rep also told me to come over here and ask...

I am looking for the following parts for Kioti DK-45SE HYD Cab: outside mirror, windshield reservoir, and both tie rods. I hope to find aftermarket parts that are lot cheaper. Several years ago, I read a post somewhere that some auto tie rods would fit, but I can't find the post. All ideas...