Hi, I recently hooked up my auger, pushed the PTO button, and it lit up but no rotation. I also tried switching the Manual-Off-Auto selector switch but no go. It's been a while since I've used the PTO, and I think this has happened before, where it didn't work, and then after a while it worked! Should I open up the dash and wiggle and/or clean some connectors, or on the firewall? About a year ago I could not start the tractor, and finally took it into a shop, and they found a connector under the hood on the firewall needed cleaning - that was all! Is the PTO solenoid under the dash covering, or where would I find it? The fuse on the firewall for "Key Stop/PTO" seems to be good; runs ok.
'03 2810 PTO Lights up but won't Rotate
- Thread starter mbaker
- Start date
- Views: 980
Offroadtek
Bronze Member
If possible, check for voltage at the switches and solenoid and that the solenoid is grounded still. It's probably an electrical issue.
